Find a local electronics repairer in Gold Coast

Gets to 24 mins and has a check water fault. Have tried resetting but still the same.

Just to hook up washing machine to the raps so we can use our washing machine

I need these steps replacing same design in merbau. I have the materials just needs cutting constructing and attaching. Thanks

I have an air compressor that draws 90 amps. I would like Anderson plug wired to the rear of the car that is at least rated and fused to 90amps.

Handyman required to cut aluminium strips to fit ceramic cooktop. Require an angle grinder to cut the strips.

I have FTTP NBN with the NBN fibre box (NTD) located in the garage. Currently, my router connects via ethernet to a data point downstairs (study). I want to keep this existing downstairs connection and add a second Cat6 ethernet point upstairs so I can relocate the router out of a new nursery. Scope of work: • Run one additional Cat6 ethernet cable from the NBN box in the garage to an upstairs room • Install one ethernet wall plate upstairs • Keep the existing downstairs data point active • Terminate and test the new connection House is two storey. No NBN or ISP work required. Licensed cabler required.

Require 7 tree stumps to be cut as close to the ground as possible and then disposed of. Also require 8 plant holes to be dug (post hole digger would probably be required due to roots in the area

Hey! Need two holes patched up in the bathroom. And potentially need filling of a 50c sized dent downstairs. With the bathroom holes, one is an inspection hole directly above the shower head and the other is broken gyprock hole from a broken off towel rack. I will paint. Ideally need it done before the 23rd.

My upstairs bathroom is out of order as the taps do not turn off. The washers have been changed. But still dont work properly. I would like to have these fixed and be water tight and operational. As its an old build there is no isolation valve which makes future works hard. I want an isolation valve installed.

I need new cords on my ghd straightener, dryer and air styler

Posting for my parents place. Want to completely replace the entire bench tops with a simple ikea worktop. Might consider getting a new sink as well depending on budget.

I need two bedroom walls prepped and painted (two coats). Substantial sections of existing paint peeled off after removing peel and stick wall paper. Will need appropriate prep (sanding etc) to ensure the surface is smooth and you can’t see surface transitions. In addition there are around 5-10 small touch ups required on other walls (approx size 50c piece) where a small patch of paint has peeled off with 3M renters tape removal (fill, sand and paint). I’ve obtained colour matched paint (4L). Tasker to provide other necessary tools/ floor coverage to ensure no paint goes on carpets and fully clean up after job. Job must be finished before 12pm on Monday 1 Dec. Thanks in advance

3 trees need tops trimmed off them. They are tall and thin so wouldn’t need a chainsaw. The stand alone ladder would need to reach 5m high as we don’t want the tree leant over and roots damaged. Type of gardening: Other Size of garden: Under 50m² Has green waste bin: Yes

I need two large stumps removed. Pics attached.

Renovating laundry. Need washing machine taps lowered to roughly 700mm off the ground. Will be a bench top going in so the aim is to keep the taps and hoses hidden. Pipes are copper.

We need to remove existing basin tap set and install a new 3-piece set. Work required: • Remove old hot/cold taps and spout • Install new set • Replace the old copper tails with flexi hoses (I have already purchased the flexi hoses) • Connect everything, seal properly, and check for leaks • Access is standard under-sink vanity

I just need someone fo chainsaw 2 x large tree stumps to ground level But we will clean up mess just cut up so we can lift to the Ute tray

Bring 4 large panels and 3 small panels of wall panelling up 14 flights of stairs in a unit building. They are quite heavy the big ones being 35kg. 2 person job.

Taps need reattaching on replacing

Need several small palm stumps and roots removed from my garden bed (see photo). The palms have already been cut down — just need the stumps dug out or ground down so the area can be leveled and covered with mulch afterward.