Find trusted local electricians in Yatala SA

Require an electrician to install a 32 amps PowerPoint in the garage. For my EV car that can take 7KW charging. We are on single phase. The meter box and the garage would be like 15 linear meters away. If you have any other questions please ask. Send your offer for review - thanks.

I have a downlight which isn’t lighting up, while 5 other downlights on the same switch are fine. I’ve removed the downlight and noticed that the adapter that was connected may not have power. I’m hoping it’s just the wire for this light has been dislodged

I need a licensed electrician to replace the broken/damaged switch on an existing wall power point, as shown in the attached photo.

3 way light switch outside,2 way light switch inside, timer push button switch outside

I’d like a power point installed in my storage space under the staircase. The room next to it is my laundry.

I have a pendant light that I would like to have installed above the kitchen counter and hard wired so I can turn it on and off at the wall

Description Looking for an honest and trustworthy licensed electrician to attend a rental property in Salisbury East and complete the following: 1. Ceiling fan – inspect and fix/secure a ceiling fan that appears to have dropped/come slightly away from the ceiling mounting. 2. Exterior wall light – remove existing exterior wall light and replace with a new light fitting (I can order click n collect at Parafield Bunnings if easier for you) 3. Electrical safety/compliance check – inspect the property’s electrical items/installations and advise of any safety or compliance issues, including electrical items/wiring in the carport/covered outdoor area as well as remaining fans in bedroom and lounge (ensure securely attached) 4. Vacuum and tidy any areas where work was completed ie bedroom before leaving premise Please include labour/call-out in your offer and advise if there would be any additional costs. Must be a licensed SA electrician. Ideally looking to have this completed before Thursday’s rental inspection

Need handman to fix electrical wirings, connect TV, change door locks. Plumbing - water leakage under sink , shower door fix

Need a compliance certificate for the solar system.

Power switch got loosen and fell off at the end. I opened up the panel from the wall and realised it is out of my capability.

my mum’s too short & gets vertigo to change the battery and I’m also no help as I also have the same issue - can someone please come & do it for us? we have high ceilings

I have two ceiling fans to install upstairs, one replacing light, second to go in the middle of room new point. I have the fans, ventair brand with remote controls What is the price is per fan? As I may buy one extra.

I have two brand new indoor fans I need installed. Old fans I can remove prior to the installation,

One of the buttons on a two-gang Clipsal wall switch is becoming difficult to press and does not operate smoothly. I need a licensed electrician to: Inspect the switch and wiring Replace the faulty upper switch mechanism, or the complete two-gang switch if required Supply the appropriate replacement parts Test both switches after installation The existing plate is marked Clipsal C2032VH Series.

Looking for an Electrician to fix a light switch. The middle broken switch per pic.

AGL says 'Non operational isolation device identified in meter installation'. Need electrician to inspect and resolve Fee is for call out, can discuss further charger

Need a single light switch replaced and a double power point, hardware will need to be included

I would like 4 power points installed 2 in the outdoor entertaining area and 2 in the carport.

Re-mount one power point & light switch in a new ensuite bathroom, and replace one light switch in a bedroom which is flickering, and on a dimmer. It’s an old switch and was installed upside down.

Need an electrician to help with kitchen Reno’s. Scope: - put 3-4 new power outlets in, including running a wire on the ground to the new island (tile has already been removed so no digging/jackhammering should be required) - terminate and close off (plaster?) old power points/wires - put in new power for oven (there is a socket right next to the oven) I estimate it to be about 2 hours of work.