Find trusted local electricians in Wynnum West

Install 3 EasyVJ Wall Panels – $120 Looking for someone experienced to install 3 Easycraft EasyVJ panels onto one bedroom wall. Wall size: approx. 2.3m high × 2.92m wide Panels: 3 × 2400mm × 1200mm EasyVJ sheets Location: Wynnum We will supply the VJ panels. They will need to be trimmed to the correct height and width to fit the wall and installed neatly. Straightforward feature wall installation. No painting required. Budget: $120 Ideally looking for someone who has installed VJ/EasyVJ panels before and has their own tools. Please let me know if you can supply the appropriate adhesive/fixings, or if you would like us to have these ready.

Install double power point in asbestos wall

Just cleaning up electrical cords

There are 30 downlight bulbs to be supplied and installed. I need a combination of smart types for lounge and dining mainly and simple types for two beds and bath. All to have dimmer. I need to have a quote covering all items and any required certification.

Install smoke alarm in my house. One room doesn’t have one fitted and needs to be.

Install Three ceiling fans with lights.

I need to 15 amp power point nstalled for a new spa I got for Christmas. It will be outside, on the back of the house i think

I just need one panel isolated, not taken down just need it disconnected while I wait for insurance to arrange replacement

Licensed electrician needed for installation of new freestanding oven. It will need a new cable from the switch board. Access for cable is east and hole is already drilled through floor. The location of the oven will move to a different wall as shown in the photo.

1. 7 X lights replacement (living room, kitchen, bathroom, toilet, entry hall, two outdoor) existing ones with standard LED ceiling lights- only installation 2. 2 X Fan replacement (living room and bedroom) - only installation 3. 1 X Fan Installation (study room) - only installation power available 4. 1 LED down light already purchased, supply and installation of power board will require changing to 6 buttons from 4 5. 1 Power sockets (inside cabinet) for vacuum cleaner - Supply and installation 6. 1x Motion Sensor light installation - only installation will require power source Compliance certificate required

A rodent chewed on the insullation around the AC wiring and caused the AC to blow with a loud bang. AC has been replaced since, but other appliances also stopped working around the same time so it’d be good to make sure everything is well & safe. I also purchased a new light for the patio, would love the quote to include the replacement of this as well (if any materials other than the light are needed quote needs to cover that too)

I have a few small jobs done, replace a light switch, changed 3 down lights and check on the ceiling fan.

After the cyclone the aircon which is plugged into an outdoor outlet stopped working. I need an electrician to come out and examine whether the plug or the outlet is the issue and replace the faulty part

Qualified Electricians only. I need the electrical. wiring connected on a kitchen stove (just a straight swap out, its already hardwired and the old stve removed), 2 kitchen lights and 2 wall socket replacements (straight swap). I ONLY need to the wiring done, I will do the fitting of the lights and stove after. Simple job that should take an hour to 90min max so can be at the end of your day. I have a ladder. No Rubbish to clear.

We are building a camper box on the back of our truck, and we are at the stage where we are insulating and cladding walls. We can’t complete this job until the electrical roughin for power points has been done. Once the wires and power points have been roughed in we can complete the wall and kitchen installation. Then we will need the electrical system connected to the 5000 W inverter. There is also a 240 V hot water service that needs to be wired in. I already have 10 double pole double power points and some electrical cable and 3 16 amp double pole circuit breakers. We need an electrician to help start the project and then come back to complete the project and provide a safety certificate on completion. We need this urgently as it is holding up the rest of the build. Budget is unknown so took a guess!

Electrician required: - replace faulty ceiling fan -‘disconnect & remove 2x wall lights - relocate 1 x power point - disconnect 1x power point

AIRCON REPAIR, Mitsubishi avanti plus 3.5kw which needs to be retubed and regased with r32, Installer deceased so can't go down that route for repair. The unit has be tested whilst running by non fridgey but cerified installer and was showing only 250kpa on the gauges whilst running so was pumped down. Connection from the back of head unit is partially in cavity wall but can be accessed for leak testing, however this means that the connections need to be made to the indoor unit and then have the pair coil pasted out throught the wall before making the connections to ourdoor unit and testing.

I'm looking for someone to move my solar inverter (just up the wall or along the wall). I also want a new power point installed above fuse box. I'm happy to provide the power point.

I have a very old IXL Tastic 3-in-1 heat, light and fan unit that I want to replace with a unit I bought from Aldi. Also replace an old power point.

Disconnect two lights for painting