Find trusted local electricians in South West Sydney

Need a powerpoint installed for a recessed fireplace and another external one for the tv

Need to install led lights under kitchen cabinet

I just need to replace five old wall light switch with the budget of $150. Please contact me if you hold a electrician license near Liverpool area.

Need the plug to a radiant heater replacing . You don't need to be an electrician but you do need to be confident you can do this safely.

Hi, I am looking for a reliable and professional handyman or licensed electrician to complete the following installations at my property in Edmondson Park: * TV wall mounting (including installation of the wall bracket) * Washing machine installation * Cooktop installation * Toilet spray installation in the bathroom Please let me know your availability to complete these jobs. Thanks & regards.

All other materials, apart from those listed below as "Supplied", must be provided by the electrician. For product warranty purposes, I require evidence that the installation was completed by a licensed electrician (invoice, receipt, licence number, or Certificate of Compliance where applicable). Task1 : Replace existing floodlight with new supplied floodlight. Task2 : Replace existing outdoor light with new supplied outdoor light. Task3 : Replace existing five (5) outdoor batten lights with five (5) supplied outdoor lights. Task4 : Replace existing bathroom light/exhaust unit with new supplied light/exhaust unit. Task5 : -Install two (2) new LED floodlights (supplied). -Replace existing 2-gang switch with supplied 5-gang switch. -Connect each floodlight to its own dedicated switch. Task6 : -Install two (2) new up/down lights. -Connect both lights to the 5-gang switch installed in Task 5. Task7 : Replace existing light holder as it is currently loose/unsecured. Task8 : Inspect and replace existing 1-gang light switch if required. The switch may be water damaged and has previously produced a mild electric shock after being used with wet hands. Please investigate and rectify as required. *** For Task 5 & 6, existing 2 Gang switch location can be reused. Garage roof cavity is accessible. Maximum cable run for front up&down lights is approximately 7-9m from switch location to proposed light locations. Surface conduit within the garage is acceptable if required.

Help re wire electric motorbike

Install kitchen bar light, move up power points

Please see quote note at bottom Open or Restricted Registration cabler or sparkie needed to install and commission 14 runs of cat6a. NBN to Garage x 6 Garage to Living x 4 Garage to Bedroom x 4 Termination on wall plates with appropriate cat6a mechanism Installation is in a townhouse. Your price here is for your time, skill and equipment. # Quoting We will pay for materials as invoiced by the wholesalers plus GST. I'm estimating that this is eight hours work, and given your quote is time only, understand that my mental maths is going to be quote divided by eight. If you are two to four times the standard hourly rate - I'm not going to accept the quote. I'm not a difficult customer - I just know this space well.

Need 2x double power outlets installed, all will be close to another power outlet so easy electricity connection and roof access. Thank you! (images attached - marked in red where needs to be installed).

Hi, I'm looking for a licensed and insured electrician to complete a small fit-out in my apartment in Liverpool 2170. Work required: • Install 1 or 2 new double power points (GPOs) – exact number and wall locations to be confirmed on site • Install 2 x pendant lights (light fittings supplied by me). You will need to bring the switches • Install 1 x downlight (fitting supplied by me) What I need included in your quote: - Work carried out to AS/NZS 3000 standards - Testing and a Certificate of Compliance (CoC) on completion I have attached photos of the of the ceiling and the wall where the installation will happen

Looking for a licensed electrician to complete two replacement jobs today: • Replace existing garage batten light with new LED batten light (new fitting supplied) • Replace existing bathroom heat lamp/light unit with new unit (new fitting supplied) Details: * New fittings supplied by me * Existing fittings already accessible * Looking for a neat and professional installation * Located in Oran Park * Available today Please get in touch if you’re available today and can complete both replacements. Photos attached

3 x pendant lights Re-wire hot water to use solar battery

I have 15 light switches and 15 PowerPoints (double) that need updating. Not installing any new ones, just replacing what I currently have with new Clipsal ones. I will supply materials (light switch and PowerPoint). Just need install cost.

I need someone to repair a cut electrical cable in an outdoor parking bollard.

I currently have a single light switch on the wall for my downlights and I would like to change it to a wall plate with 3 switches and 2 power points. I have attached the current switch photo and the style I want installed.

I need someone to install solar panel mesh on my current solar panels as i have noticed some pigeons. i have 3 array of solar panels on roof. Your task will be to first clean the solar panels and clear the debris then install the solar panel mesh. I can buy the mesh kit if required. Red area has poop build up

I have a light not working, I have replaced the bulbs but have the same issue.

MESH & CLIPS PROVIDED (attached) > Looking for an experienced installer to install bird mesh around solar panels on a tiled roof property in Edensor Park. Goal is to prevent birds nesting underneath panels. Details: Double storey house Tiled roof Solar panels already installed Full perimeter mesh installation required Must be properly secured with clips (provided - no damage to panels) Requirements: ✔ Clean area first. ✔ Experience with solar panel bird proofing ✔ Must bring own tools and equipment ✔ Neat, secure installation (no gaps) ✔ Prefer someone who has done this before Please include: Your experience Photos of previous work (if available)

Please provide the quote I need a licensed electrician for the following: 1. Replace a burnt/damaged 10A wall socket (GPO) • See attached photo • Check wiring behind wall for any damage 2. Install a new dedicated 15A outlet for EV charging • Run directly from switchboard (located on the other side of the wall) • Include RCBO / safety protection • Suitable for continuous EV charging load Notes: • No adapters will be used — proper EV setup required • Easy access, short cable run (same wall as switchboard) • Please include materials + compliance certificate