Find trusted local electricians in Mermaid Waters

Looking for a licensed electrician for sub-contract work around the Gold coast - working along side main electrician and or autonomously. Must have toold and transport

Hi, I’m looking for a licensed electrician to do a small lighting job in a kids bedroom. It’s a single-storey standalone house in Mermaid Waters, with access through the ceiling/roof space as required. Scope: 1. Cut 4 x 90mm ceiling holes 2. Wire and install sockets/downlight points for 4 Philips Hue downlights 3. Remove existing ceiling fan 4. Install a LIFX SuperColour Ceiling Light Model: 38cm White Trim I already have the lights. Need someone who can supply any required electrical fittings, cable, sockets, connectors, etc, unless you prefer I buy them first. Because this is a kids bedroom, I need the room properly protected before work starts — bedding, flooring, etc — and fully cleaned up afterwards, including dust and debris from cutting the ceiling holes. Must be properly licensed and able to complete the job safely and neatly. Flexible with timing. Thanks!

Need 2 basic pendants changed over. Change over two existing pool lights to new ones. Check one switch Check pool gate switch Check switchboard for compliance Fit one blank plate Replace two existing downlights, (install only) Possibly fit and certify some smoke alarms but that is excluded from this price. Estimate 3 hours work so price should be hourly rate x 3 is the minimum if it goes over will be adjusted based on hourly rate. Please advise if install and certify smoke alarms as well

Hey I just need to connect 4 MR11 sockets to 1 line and then put a plug on the end, and I guess a driver if needed? I have a little custom light I want to test. I have the MR11 sockets, I need you to provide the Aus Plug and the driver if required, oh and the bulbs if you can?. I also have the same job with 4 MR16 sockets too, so may as well do both at the same time.

I need a 15amp GPO installed externally for our SPA, I need additional GPO installed in the kitchen and in the garage.

Move 5 solar panels due to a patio roof install. (can be 4 as well since the last one could stay, whatever is easier). Panels to move circled in red, not sure where they'd go, maybe in the green area? (back of the house faces mostly north, slightly west)

Move the lowest row of 5 solar panels (circled in red) to a different area (perhaps where marked in green) since we are installing a patio roof.

Need a HVAC electrician to disconnect a split system aircon that will be reused again on a single story house that’s being demolished

Replace the burnt/damaged outlet

Install Kitchen 120cm LED strip Install Laundry 120cm LED strip Install Light over Dining room table Install outside entrance spot light Fix broken light socket on hallway light Fix loose connection on electric chair hand control

Looking for someone to install one (possibly two) AC split systems at my place. Planning to put a split system in the living room prob around 3-3.5kW max. There is a dedicated circuit for the 6kW window box Kelvinator upstairs. Considering to also replace it for a split system 2-2.5kW or get another window wall box. Wanting to make both ran in the same dedicated circuit so no overloads. Feel free if you want to come over to have a better look and provide a quote with mid-premium brands.

Need an Aircon Technician tomorrow to: -Find the leak and repair & -Regas the unit Ducted Aircon - 4bd House - 16kw Samsung - R410A type of gas - 2.9kilos

Install 4 x down lights and 1 x fan in patio roof, will need to be all connected and installed with switch on wall

I have labeled the preferred install as 1 and the backup as 2

1. Pool light not working (floating out of its socket and 2. Outdoor light needs replacing (I’ll pickup the light in the photo). Please quote you price. Job Mermaid Waters

I need help putting Christmas lights up on our house. Around the perimeter on the roof, on pillars and the fence

This is a Ricatech RR2100 classic LED jukebox. It does not work, doesn’t have a power supply, but I would like to restore it to working order. I’m looking for a repairman to take a look at the back, diagnose the issue and fix the wiring/ re-wire the jukebox. Some info that may be helpful (this is all from google but should be correct. If you require more info or pictures please let me know) The Ricatech RR2100 classic LED jukebox features a record player (33, 45, and 78 RPM), a CD player, a digital AM/FM radio, and a line-in/out (mini jack). It also includes a five-color LED light, a wooden finish, and stereo speakers. The device measures 65.5 x 41.3 x 111.7 cm, weighs 40.2 kg, and operates on a DC 9V 500mA power supply.

Have had a fixed velux skylight installed VELUX FCM 2270 - 665 x 1885, the edges have been plastered since photo. However may need a small amount of no more gaps filler around small nail gun tacks, and a very light hand sand prior to painting (internal only , white). See pictures. Price is to include purchase of these materials (however if I find left over supply in garage prior to job, I will supply and not reduce price). I don’t want any splashes of paint on the window or surrounds. It is not a large job, but I am looking for someone who prides themselves in a great professional finish (we always have more work in future to offer)

Change outdoor downlights plus change solar batteries.

We need an electrical outlet added to our wall behind where we want our tv. As well as tv wall mount installation for 75inch TV.