Find trusted local electricians in TAS

Need to redo all,wiring for a. 5 x power socket /b. 1 x power supply isolator for aircon 2.5kw / c. 2 x external power socket /d. 2x power supply for 2 LED light strips / e. 1 x distribution board. The current setup does not meet stds. Current issues are cable terminations, RCBO arrangement, earthing not connected, circuit protection and main switching arrangement . It is a tiny house on wheels mainly all cables go to the bottom and wired around the perimeter of the trailer. The house size is 6m Lx2.4mW

Air con won’t turn on . ? Problem

1 large stove in Ceramic Electric Cooktop is not working. Right side top corner stove is not working. Model: Beko HIC641051 60cm Its may be coz of 1. Failed heating element or 2. Rear-right control/regulator has failed 3. Loose/burnt internal connection Need a Sparky to correct this issue

Reallocation of the split system heat pump (air cond) from one wall to another

Require a licensed sparky to replace approx 20 old light fittings with downlights throughout a house.

~25meter run of 10mm cable required if has to be run as pictured. But ideally prefer it run knee-height if possible. Would jummcut the run down closer to 15 over all. All outdoor and essentially straight line run.. ~15M (less if knee height) needs 32mm MD rigid/grey conduit surface mount to weatherboard house. ~8-10M need 32mm HD rigid/orange conduit run underground. Trench already dug to spec. Powerpoint provided and 40A RCBO breaker already installed in switchboard. You'll need to provide conduit, clips, couples, etc and the cable.

I need a licensed electrician to wire in a newly installed 2-post / 4-post hoist at my workshop in Moonah, Hobart. Requirements: • Must hold a current Tasmanian electrical licence • Certificate of compliance provided on completion • Public liability insurance preferred Photos of the hoist, its spec plate and the switchboard are attached.

Electrician Needed – Cable Repair 🔌 Looking for someone who can repair the damaged electrical cable shown in the photo. It was accidentally damaged during a move. Ideally, I’d like to have the damaged section repaired, the wires properly reconnected and safely insulated, rather than replacing the entire cable. Located in Lindisfarne. Please message me if you can help or know someone who can. Thanks!

I need a handy man to fix multiple things in my house. I need curtains/blinds fixed as they've come off their tracks. I need my cupboard doors drilled back on. Fix leaking from shower taps. Electric garage door doesnt open any more- likely need for realignment. Fan above stove isn't working. I would be keen to get a quote if anyone has ability.

We need new solar panels in Norwood. We hope to get a quote on price.

Seeking an electrician perhaps retired or someone with spare time, that could provide some hands on practical training for an electrical apprentice. This wouldn’t be on a worksite, rather at home and creating mock tasks etc… have all tools available. Fee negotiable depending on hours worked etc.

Looking for a fully licensed and insured electrician to install an EV wall charger on a fixed project basis at my property in [Your Suburb]. Project Details: • Charger Supply: I have already purchased and supplied the unit [still boxed with manual]. • Phase Type: [e.g., Single-Phase / Three-Phase] • Mounting Location: [e.g., Inside the garage / On an external brick wall] • Switchboard Distance: The main meter box/switchboard is approximately [e.g., 5 metres / 15 metres] away from the mounting spot. • Cable Path: [e.g., Directly through the back of the wall / Through the roof cavity / Via external conduit] What the Project Scope Covers: 1. Securely mounting the EV charger unit. 2. Running a dedicated 32A circuit from the main switchboard to the charger with appropriate RCBO/RCD protection. 3. Testing, commissioning, and configuring smart/load-balancing settings (if applicable). 4. Supply of all necessary cabling, conduits, and electrical consumables. 5. Providing an official electrical Certificate of Compliance (e.g., CCEW in NSW) upon completion. Requirements: • Must be a registered, licensed electrician (please provide your licence number in your offer). • Prior experience with EV charger installations is highly preferred. • Compliance with AS/NZS 3000 electrical standards. Please provide your fixed-price offer for the total project, including your earliest availability.

Im demolishing the ceiling in this extension on a house we bought recently after historical rodents and water ingress. Seems to be dry in there now. We need an electrician to remove the light fixture and the make the wire safe so i can continue to demolish. The ceiling was built in the 2000s.

Scope of works: - Convert 1 x fluorescent light to new pendant light including installing new ceiling rose - 4 x Replace old pendant lights with new ones I'll provide new lights and ceiling rose. Please confirm your electrical licence number in your quote. Flexible timing.

Our spa was working fine. Turned it off for a week and now it keeps tripping out at the circuit board.

Install downlights, exhaust fan, pendant lights and GPOs, including rough-in. Complete electrical isolation before renovation starts. A detailed scope of work will be emailed. Final pricing will be agreed once the detailed scope is provided.

I am looking for a licensed electrician to safely disconnect and remove an obsolete off-peak Tariff 61 circuit at my residential switchboard so I can upgrade my property's electricity plan. Key Responsibilities: Physically decommission the hardwired Tariff 61 circuit at the switchboard. Ensure the switchboard and remaining wiring are safe. Submit an Electrical Works Request (EWR) to TasNetworks through the Connections Portal to formally trigger the tariff removal process. Supply a Certificate of Electrical Compliance (CEC) for the completed work.

Looking for a licensed electrician to swap a censor light over

Airtasker Title Licensed Electrician Required – Roof Wiring Inspection Description Looking for a licensed electrician to inspect electrical wiring in the roof cavity. Inspection identified: * Unorthodox electrical wiring * Inspect wiring * Make safe if required * Repair or replace non-compliant wiring * Provide advice if additional work is required

I just need to change the switch in bathroom or could be the light and Fan.