Find a local electronics repairer in TAS

I am moving house and would like someone to do some painting, mainly touch ups around the house.

I have wooden floorboards in an old farmhouse which are not tongue in groove. They have gaps between them in some rooms through the gaps I can see light from the ground underneath. The gaps range from 1-3mm The two places I need these gaps filled is in the bedrooms. About 6m^2 each. - Due date: Flexible

2 x heat lamps are blown You need to buy 2 same lamp bulbs from Bunnings and then replace them it is in the ensuite

Dig out and remove stumps of hedge plant (Tecomaria Capensis). Trellis is not to be damaged but could be removed and replaced to facilitate removal of stumps. Main root ball to be removed and roots cut to prevent regrowth. All vegetation to be removed.

I recently dropped my GHD Straightener and am wondering if anyone can fix it? There seems not to be a place in Hobart! Happy to drop it off to you and pick it up if it’s within 20-25min of Hobart. Thanks in advance!!

I need someone with a chainsaw to cut 2 tree stumps off at ground level. They are on a bank.

i have a behringer NX3000 amp need to done the repair,its become Protect mode

Stumps are 150mm diameter, want 100mm taken off and will cover with soil, holes to be 300mm wide, 600mm deep. Will be 20 holes, Will be marked out before

Join timber benchtops, shorten benchtop to fit cabinetry, fix upper cupboards to wall, cut sink and stove holes

It has to be restarted with 14 minutes left on cycle.

One of the speaker channels has stopped working on my Sansai solid state stereo amplifier AU-555A

I need to seal the front door step of the shop.

I have a hydraulic heating system in my house and my remote is telling me there is no communication between it and the outdoor heat pump (inverster)

Battery flat. Lights still come on dash. Need jump done asap. $50

Rodent exclusion + trap setup in roof cavity We've got mice getting into our roof cavity and want them dealt with properly — not just baited so they keep coming back. The job has three parts: Find the entry points — inspect the exterior, roofline, eaves, vents, weep holes, pipe/cable penetrations and roof tiles for any gaps a mouse could get through (they only need about 8mm) Seal them off — close all gaps using steel wool packed into expanding foam, and metal mesh over any vents/openings that can't be fully blocked. Mice chew through foam alone, so steel/mesh is important. Set the traps — access the roof cavity through the internal manhole (note: this is a low Australian-style roof space accessed via a ceiling hatch, not a full walk-in attic, so it's tight and requires care on the joists) and place snap traps along beams and wall lines where mice travel. We supply: snap traps, peanut butter, a ladder, and a head torch. You supply: sealing materials (steel wool, expanding foam, metal mesh), hand tools, and appropriate PPE (gloves, dust mask — roof insulation and dust).Single-storey home in Hadspen, TAS. Please bring your own materials for sealing (let us know if you'd prefer we purchase specific products in advance). Take before/after photos of the entry points found and sealed so we know what was done. Let us know if you spot signs it may be rats rather than mice, or any other damage (chewed wiring, nesting) while you're up there.

Water went in, turned off immediately and didn’t not charged, left for 48hrs to air dry. But it still doesn’t work

Old taps which need fixing

Needing the tops cut off & shaped pittosporum trees. They are quite thick branches and main base. Greenery waste taken away as well.

Attempt to fix chips and scratches on vehicle not successful. Would like someone who knows what they are doing to minimise the damage

Toilet won’t stop running after flush, urgent fix before 2pm