Find local downlights installers in VIC

I need an electrician to do the following in a newly built ward robe: 1. Add LED (warm white dotless) lights to the wardrobe, power point already externalised, grooves and channels already in place. 2. Shift two existing and working downlights by 30-50cm and install and connect them to a motion sensor. Located in Keilor East. Available after hours or on weekends. You will provide the material and I pay for them separately. LED channel lengths are: Four 110 cm channels Six 190cm channels Four 215cm channels

I just need to replace this pendant light with a down light. I have the down light just need someone to come and install it

I need 4 or 5 down lights replaced. Ideally you have some replacements on hand, none of the ones Bunnings sell work at this apartment. I have attached a few photos. – MR16 LED globe – GU5.3 base (2 pins) – 5W – 7W – 50mm diameter (standard) I’d love tri colours but don’t think they are compatible

Install down lights Double storey house

We need an electrician to 1) replace 8 old down lights in our garage with modern much brighter lights. Supply / install 2) we have an outdoor light circuit and speakers in our front yard. The lights don’t work anymore but don’t short the circuit. Suspect the gardener cut it, but I can’t find the wire that’s cut. Tricky to access.

Need to replace entire house ceiling lights, any wiring necessary. Old light is globe in the middle and require downlights throughout. Aprrox 30 downlights. Certificate is a must

Replace existing can lights.

I have an upstairs bathroom that has a heater lamp unit in the middle. The problem is, not much light hits the actual shower area. Could I install a new led down light and have it either on its own switch or piggyback the heater lamp's center led?

Buy and install new downlights. Total of 6.

Looking for someone to help inspect and replace the blown bulbs/globes in my bathroom ceiling fixtures as they are too high for me to reach safely. 3-in-1 Heller Bathroom Unit: Left heat lamp is heavily blackened/blown (looks like it may have exploded internally).  Center globe and heat functions are currently not working.  Ceiling Downlights: Down lights are also non-functional/not turning on and need bulbs checked or replaced.

I have a faulty 12V recessed LED downlight in my bathroom. I previously had transformers switched out to fix other faulty lights, so I assume this is the same issue. I replaced it with a working globe, and it did not work. i also have one cracked double power socket I'd like replaced too

Need downlight replaced in toilet

I have 12x down lights that need replacing with electricity friendly LEDs. Give me a quote - best one will get the job! :) Licensed electrician please

Hi, I need the following electrical work completed: - Replacement of 3 hardwired smoke alarms I’m looking for a licensed electrician to complete the work. Please also let me know the estimated cost of the replacement smoke alarms and transformers. Thanks.

Need 15 down lights replaced to Led -Existing ones are hardwired- please quote for install with surface outlet plug base - quote for install only-product supplied. Don’t need any certificate Also have a one year old door bell not working if could fix that too.

Looking for a licensed electrician in Fraser Rise to complete the following: * Supply and install 6 x downlights & a dimer switch * Supply and install 1 x new power point * Install my BYD 7kW single-phase EV charger I already have the BYD charger. Looking for everything else to be supplied and installed, including any required cabling, safety switch/RCBO and electrical certificate.

Looking for a licensed electrician to fix flickering GU10 downlight. The circuit has 6 LED downlights. One particular downlight socket/fitting seem to have an issue: * When an LED globe is installed in this socket, only 3 of the 6 LED elements within that individual globe illuminate or it flickers. * I tested the same LED globe in another socket and all 6 LED elements illuminate normally, so the globe itself appears to be working correctly. * The other downlights are generally working. I suspect there may be an issue with the GU10 socket/lampholder, connection or wiring, but would like a licensed electrician to diagnose the actual cause. Licensed electrician only. Please advise whether your offer includes call-out, labour and basic replacement parts.

I have 5 MR16 LED downlights. The globes are new, but the lights still turn on and off. I need a licensed electrician to replace the 5 transformers with LED-compatible 12V transformers and make sure all lights are working properly.

Change 12 downlights in Bayswater north

install 10 downlights on eaves on two side sides of the house. Existing switch and one existing light outside can be used as the source of power. Replace two internal switches with dimmer switches. dimmer switches available only need the installation. Will need to widen the hole in the door trim to fit the dimmer switch. small house so not a lot of wire will be required. Look into the attached plan to see where these new downlights will go to estimate your wire cost.