5 Concrete contractors in Taylors Hill

I need concrete to be done on a side around 2.5 x 16 mtrs

Need an area in the backyard to be concreted. Area is 17m × 4m. Currently there are pavers laid in this area, they will need to be removed.

Driveway pavers have moved slightly from their original set position. Some have sunk. Concrete edge on one side has broken away. Would like existing pavers along the grassline and those pictured infront of the car to be reset on a solid, level base to their original position and concrete edge replaced. Flexible with time. I will dispose of waste.

Need a concrete grinder a concrete vac and a floor cleaner picked up from Milperra NSW and delivered to Taylor's Hill Vic Grinder is95 kg 1300mm high 705mm long 405mm wide Dust vac 38 kg 590mm l X 500 mm W x 900 h Floor cleaner 45 kg 890mm l x 470mm W x 1100mm h

Setup and concrete, Short part

Approximately 4.5m × 17m. 100mm thick plain concrete.

Looking to get aggregate concrete laid in the backyard. 3 areas all joint to each other. Measurements (LxW) are: 9m x 5m 9.3m x 1.5 11m x 1.5 Looking for quotes!!

Removal of old caulking between exterior wall of the house and the concrete paving and then re-caulking. Total of 18m.

The steel posts are installed as retaining wall but some of them are left hanging in access need to cut them so that they don’t look bad. All you need is a heavy duty angle grinder with few steel cutting blades to cut these 75mm h-posts. Thanks Please see pictures attached.

Need 2 shower bases cut 70-80mm deep for new showers. Sizes: 2250mm x 900mm & 1200mm x 900mm Job location: Taylors Hill

We need uneven concrete path crack repaired and make it look even. Photos attached Path in photo is connected to driveway. We are expecting this job will not make our driveway look ugly

Repair cracked driveway and possibly reseal. The stamp is called walkway

Grind down my driveway and paths to concrete. Currently painted and want to expose the concrete underneath!

The steel posts are installed as retaining wall but some of them are left hanging in access need to cut them so that they don’t look bad. All you need is a heavy duty angle grinder with few steel cutting blades to cut these 75mm h-posts. Thanks Please see pictures attached.