Find experienced local carpenters in Stafford Heights

We need 60sqm of skirting installed(half splayed). We will supply. We also need moulding installed above wood panels 5.5sqm. Please see pictures for reference of what we have currently and would like it to match. We also need a pocket door installed 2040x770x90. Opening is currently archway. Please refer to picture to see plan. We will supply. Wall is not load bearing and wanting the job finished ready for painting pls.

Need a 920 door jamb installed (supplied by you) and door hung 920x2040x35. Door, hinges and handle all provided. Internal door. This is not a straightforward install. Door opening is 930mm. Opening depth is ~175mm. Opening height is 2050 floor yet to be laid. Likely plasterboard removal required for door jam size only to create space needed and expose wood frame. Existing frame made by stud wall standard wood frame. Recommend site visit first.

Need a chippy/cabinet maker to install overhead cupboards then cut down kickboards, finishing off panels and bulkheads to matching heights. All materials for job are on site. The finish panel around the fridge needs trimming down before fitting. There is a total of 6 finishing panels to be installed and 5 overhead wall. One wall cabinet needs hole cut for vent pipe

Removal of existing door and window in frame (1700mm wide) and install new French doors (1420mm) hard up against left support line and patch wall after. We have the hardwood frame pieces for the new French doors.

I need to close 2 holes in the exterior walls after removal of current old window aircons. The hole dimensions are - 560×380 (upper kevel) and 470×360 (lower level). Brick wall external where upper level aircon is. Unsure if similar bricks can be available. Alternatively a thick timber piece painted in relevant colour will need to be installed. Ground level aircon is installed in a thick timber piece painted white. Looking to change this to a window.

I would like a simple gate abour built and some garden edges created in my front yard. Also could do a second job of finishing some sanding on a small deck and painting with a decking oil. - Due date: Flexible

Measure, cut & Fit approx 2x2.0m lengths of kickboard under existing kitchen cabinets- kick board supplied - Due date: Before Tuesday, 28 November 2023

We have a dual door which we want the walled filled in and plastered over, materials will be supplied and I can assist - Due date: Flexible

The right side railing on our deck stairs is very wobbly and needs to be fixed. Not sure if the posts need replacing or not. Also a few loose pailings on our front patio stairs. - Due date: Before Saturday, 11 November 2023

Work alongside a carpenter for 1 day - Due date: Needs to be done on Tuesday 1/11/23

The deck railing has broken off as you can see in the picks. We need someone to replace the bottom rail and secure everything in this one section of the deck. We need it done asap as we have a gathering on the deck on the 19th May and can’t have people on the deck with this like it currently is. - Due date: Before Saturday, 20 May 2023

Minor water leak in roof which has been repaired but need a little part of the ceiling stain blocked and re-painted. Please see photos attached don’t have the paint so you’ll need to get it matched. Two stains in total - Due date: Flexible

To build a pool pump cover and shed on the existing pool pump (pictures attached). Approximate measures are 1100mm D x 2800mm H x 2800mm W, with at least one shelf (two will be ideal) at 1100mm from the base. It will need to have an enclosed back (at least half, or up to the wall edge) and an edged top cover. The front door will need to be at least 150mm above the ground due to the pool edge (or to be a sliding door). Prefer oiled/stained timber but am open to suggestions. Need to be done by the first week of Feb but am flexible with dates and times to some extent. - Due date: Before Friday, 3 February 2023

Deck boards: Repair 2 x single deck boards, finished work MUST MATCH the existing boards/blend in: one needs a repair or replacement of small section at the end, the other board is a little warped. Slide: realign slide so that it sits correctly on the pool coping (currently crooked and also hanging off one side - misaligned due to a recent replacement of the fort floor boards, built back in a way that didn't take into account correct alignment).

Mid renovations and cover strips need to be put back on, 4 x doors hung and skirting required in various areas - Due date: Flexible

My dog as chewed the outside of a window wood frame. It looks like the whole frame may need replacing and it looks like the bottom frame is what holds up the window. Need it fixed asap. Please send through quotes - Due date: Flexible

I’m looking for a carpenter to build a 3x3m timber bench seating. At this stage I’m just looking for a quote for the work. Image of inspiration for reference as to the style of build. - Due date: Needs to be done on Saturday, 12 November 2022

We need a ramp built on our back steps so that our dog can use it to enter the backyard. It'd probably need to be wood with rubber on it for grip.

Paint of cupboard doors and drawers + benchtop Cupboard door colour from Dulux renovations range - beige calm and bench top in white.

Outdoor children's fort requires 3 fixes below. Looking for an affordable, practical fix (no longer using but want to make safe for little guests) that blends in well with existing finishes. Materials to be supplied by tasker - please also mention the flooring material you are considering in your reply. 1. floor to be installed (previous timber floor slats were removed due to rotting, the base remains as seen). Approx area 150cm widest x 230cm longest (however total area is less than 345cm as the floor is not a rectangular shape, more triangular) 2. ladder to be tightened/secured (a little loose on one side) 3. wooden beam "railing" on one side has has fallen, needs to be re-secured to other beam - Due date: Before Friday, 13 May 2022