Find a local Tasker to help you make a kitchen cabinet in East Melbourne

Require the kitchen cabinetry doors and shelves resized (made smaller) to allow for a greater height from floor to ceiling.

Kitchen cabinet removal (must take cabinet with you)

Kitchen cabinets needs modifying to fit our fridge. Space is about 10 cm too short.

My kitchen cabinet is 10cm too low for my fridge. I’d like the bottom trim and shelf removed, and the sides/side trim shortened by 10cm, before re-attaching the bottom shelf and trim. 5cm removed from the top and bottom of the doors too. The trim is currently attached with wood glue and the bottom shelf to the sides with nails.

Wanting to Reno our kitchen and have new cabinets made. Open to either just new cabinet doors and keeping the current kitchen shell if feasible, or replacing entire cabinets if required

I would like to fit a second oven to existing kitchen cabinetry .. currently the space is only 30cm in height and it needs to be 45 . If a cabinet make could remodel the cabinetry so I could fit a second oven this would be my preference . I currently have a small microwave in there as in picture

Installation of pre-assembled kitchen cabinets. U-shape kitchen - plans attached. Note: walls are brick

1. Task Title: Modify Overhead Kitchen Cabinet to Increase Fridge Height Clearance (Fridge Height: 1833mm) ________________________________________ 2. 📋 Task Description: We’re looking for a skilled handyman or cabinetmaker to modify the overhead cabinet above our fridge cavity. The current fridge space is 960mm wide and 1760mm high, and we need to increase the vertical clearance to fit a new fridge that is 1833mm tall. This will involve removing the overhead cabinet, reducing its height by trimming the bottom section (including the doors), and then reinstalling the modified cabinet higher up to create sufficient clearance. ________________________________________ 3. 🔧 Scope of Work: 4. Remove the existing overhead cabinet above the fridge cavity. 5. Trim the bottom section of the cabinet to reduce its height, including resizing the cabinet doors. 6. Reinstall the modified cabinet higher up to increase the fridge cavity height. 7. Ensure all cuts and adjustments are clean and professional. 8. Clean up any debris or dust created during the work. ________________________________________ 9. 📐 Measurements: • Current fridge cavity width: 960 mm • Current fridge cavity height: 1760 mm • New fridge height: 1833 mm • Recommended minimum clearance above fridge: 30–50 mm • Target fridge cavity height: At least 1863–1883 mm • Refer to attached photo for visual reference. ________________________________________ 10. ✅ Requirements: • Experience in cabinetry or carpentry • Must bring own tools and materials • Attention to detail and clean workmanship • Ability to complete the job efficiently and safely

Cabinet slab is broken, its wooden, Under the sink

Modify existing kitchen cabinet for making space and install dishwasher & microwave oven . Dishwasher & microwave wave are not yet bought and can be bought as per advice from you after space measurement. Intended location of dishwasher and electric oven as per photos. Will require adjustment to cabinets. Similar colour of cabinets(white) or doors to be installed as appropriate.

We are moving to a new house and our fridge(92 cm width) can't fit into the fridge space(80 cm). We need to trim.down the adjoining cabinet to make space for the fridge.

I need repairs done to cupboards in Kitchen and Laundry. Just put in bigger fridge so need to adjust cupboards and trim around the new fridge. See photos. Can you come and we can talk about what you can do and cost etc. small job but could be bigger job if you have some good ideas . Suburb is Ashburton in Melboirne. Can you come early this week and do the work asap .

Build new fridge cabinet to replace existing one, and new doors for current kitchen/ euro laundry.

I would like to remove the open shelves from my kitchen island bench and build closed cabinets along the entire area where stools were supposed to go.

Seeking experienced cabinet maker to fix poor design of existing kitchen cabinets housing two built in refrigerators. Existing refrigerators need to be temporarily removed and an air vent/space installed (with fans?) to rear of cabinet to facilitate air flow and exhaust of hot air at rear of refrigerator into ceiling above. Also, door hinges need replacing as they are sagging and allowing doors to rub together. Price negotiable depending on solution.

3 large kitchen drawers need new slides/runners installed. May also require some minor changes to the drawers.

Resizing the kitchen cabinet to fit in a larger fridge. When I moved in, I had to remove the cabinet on top of the fridge because my fridge is tall. I need help to resize the cabinet (shorter) and install it back to the cupboard.

Take off the panel underneath the oven, shave 5-10mm off and install it back

I need a gentleman with minimal carpentry skills to make one extra shelf out of shelving material that I have for five kitchen cabinets. The shelves I have for this just need to be trimmed a little so they fit. The kitchen cabinet are standard size if not a little smaller. I'd appreciate it if you would please not ask for pictures. Thank you.

Require my Kaboodle flat pack cabinets, kickboards, spacer panels and doors to be installed. There may also be a couple of cut outs for the plumbing/power etc. All the flat packs are already built.