Find skilled builders in QLD

Clean and seal driveway in Sippy Downs 5 metres wide x approx 10 metres @James C

6m x 3m x 2.4m on existing slab. Has as extras a portal frame and flashing kit

Looking at cementing side of my driveway. Approx 25m2

Assemble 6m x 3m x 2.4m H easy shed on existing concrete slab … I’m after a highly experienced easy shed installer please . This shed also has as extras the … portal frame & corner flashings …. I will be onsite as an extra set of hands when or if required …. Ideally install next Friday 18/9 or sat 19/9

See my original posted task

cut a 60 cm x 60 cm hole into the concrete driveway, New balcony post needs to go in

I’m looking for someone experienced to assist with a small garden shed project at my home in Branyan. I am purchasing the following shed from Bunnings: Absco Sheds 3.00m x 2.26m x 2.00m Monument Premier Double Door Garden Shed The shed will require a suitable reinforced concrete slab, followed by assembly and secure anchoring of the shed once the slab is ready. Work required I’m looking for someone who can assist with the complete job, including: • Site preparation and levelling • Formwork • Concrete slab suitable for the shed • Approximately 0.7 m³ of concrete, based on a 100mm-thick slab over the 3.0m x 2.26m shed footprint • Appropriate reinforcement/mesh • Finishing the slab ready for shed installation • Assembly of the Absco shed • Secure anchoring of the shed to the concrete slab • Clean-up and removal of any excess materials/rubbish Important access information The shed location is at the back of the property. Access is through the garage, and there is NO vehicle access to the shed location. Please take this into consideration when quoting, particularly for transporting materials, concrete and equipment to the site. I will purchase the Bunnings/Absco shed myself. It will be delivered and ready on site to start job. I’m looking for someone with experience in concrete slab preparation/pouring and garden shed installation, who can ideally complete both parts of the job. Your quote will include: • Both the concrete slab and shed assembly • Your labour and all material cost • The concrete and reinforcement The property is located in Branyan.

Need April 36m2 exposed aggregate poured. It will be boxed up ready to go Around 3.9 cube

I want to install these solar powered cats eyes. One went in easy (new cement) I tried to install it into the more established cement driveway and I only get like 20mm down before it just stops. I need better equipment. Can someone help me out?

Need help to finish a garden shed assembly. Shed is 3.8x 2.25, height 2.3. I have already assembled 3 panels and one roof panel. Tuesday I will be assembling more so This week would be good. Must have experience in sheds. Price to help or if there is two people who are experienced in sheds can finish it, Price please.

Putting small shed together from bunnings must br handy with power tool and rivet gun i done 30% of it have putn all walls and roof together and have no time to finish it

We need a small reinforced concrete slab constructed beside our driveway, against the house/boundary fence. The finished slab needs to be approximately 1100mm × 450mm × 100mm thick and completely level/flat, as it will be used as a base for gas bottles. Work required: * Saw-cut and remove a small section of the existing concrete driveway to create sufficient space for the slab. * Existing driveway is approximately 100mm thick. * Approximate saw cuts required: * 1100mm long * 120mm long * Remove and dispose of all cut concrete/rubble. * Excavate/prepare the area as required and provide a suitable compacted base. * Form up the slab. The house/boundary side can form two edges of the area, with formwork required to the remaining exposed edges as appropriate. * Install steel mesh reinforcement, adequately supported within the slab. * Pour a 1100mm × 450mm × 100mm reinforced concrete slab. * Slab must be perfectly level, despite the adjoining driveway being on a fairly steep gradient. * The new slab must not follow the slope of the driveway or simply be poured onto/joined to the sloping driveway. * Neat finished edges and surface. * Remove all waste and leave the area tidy. Access is straightforward from the driveway. I’ve attached photos showing the location and the section of driveway that needs to be cut. Please quote including labour, concrete, reinforcing mesh, formwork/base materials, concrete saw cutting and removal/disposal of the old concrete. Please also let me know if you have experience with small reinforced concrete slabs and whether you have your own concrete saw/equipment.

Remove floor and wall tiles in 1960 x 2740 laundry and remove free standing sink in preparation for renovation

I’m needing someone to install an EasyShed on an existing concrete slab. Shed is 3x1.5m gable roof. Already delivered ready to go.

I need 65m of hybrid flooring lay over existing tiles and a concrete floor.

Bathroom Demolition Labourer – $40/hr Looking for a reliable and experienced labourer to assist with bathroom demolition on Tuesday, 18 August. Work includes: * Demolition and strip-out of existing bathroom * Removal of tiles, fixtures and fittings * Loading and removal of demolition waste * General site clean-up and assistance Requirements: * Must be available Tuesday, 18 August * Must have own PPE (safety boots, gloves, eye protection, etc.) * Previous demolition/construction experience preferred * Physically fit and reliable * Able to work safely and efficiently Rate: $40 per hour When making an offer, please include your demolition experience and availability for Tuesday.

Move 2m³ of Road Base & Sand from Driveway to Backyard Need someone strong to move approximately 2m³ of road base and sand from the driveway to an entertaining area in the backyard. 8 hours of work. Looking for someone physically fit and comfortable with heavy manual labour. Please state your HOURLY RATE when making an offer. TUES 11th AUGUST 7:30am - 3:30pm *There will be more similar upcoming work over the next few weeks*

Assemble 3x3 gable “easy shed” to concrete slab

I am needing plasterboard walls removed ASAP. Contractor needs to have insurance - this needs to be provided All tools will need to be supplied Experience doing this type of work. Needs to be able to read plans Rubbish removal to be managed by contractor Level 2 Access via lift via the basement.

Need an "Easyshed" shed assembled this weekend. Dimensions are 1.51m x 0.78m x 1.82m. See photos for more details. Based in Ashgrove.