Find skilled builders in North East Melbourne

$80 per hour nothing more nothing less so do NOT send ridiculous quotes yes I know it costs you it also costs me so if you not happy with $80 per hour SCROLL on! I need someone to assemble and build a small freestanding patio cover using pre‑cut timber and planters. All materials are supplied — you ONLY do the build. What’s already purchased: • 4 × 50cm planters • Drainage gravel • Rapid‑set concrete • 4 × 90×90 posts (pre‑cut to 2.0m) • 90×45 beams (pre‑cut) • 70×35 battens (pre‑cut) • Polycarbonate roof sheets • All screws + brackets What you need to do: • Position 4 planters • Add drainage gravel • Set 4 posts in rapid‑set concrete • Build top frame (front beam, back beam, 2 side beams) • Install 4 roof battens • Fix 2 polycarbonate sheets on top • Ensure everything is level, square, and secure No digging. No cutting. No supply. No extras. Just assemble what’s already bought. Tools required: • Drill • Spirit level • Screwdriver bits • Ladder Location: Ivanhoe (backyard patio) Estimated time: 2–3 hours

Assemble Absco shed (3x1.5m) as pictured on concrete slab in backyard Location Epping

I’m looking for someone experienced to install 2 small garden sheds on an existing concrete floor. Both sheds are kit sets and relatively straightforward to assemble. Size of each shed: 1.75m long × 0.9m wide. Concrete base is already prepared and ready for installation. Please message me with your best quote and availability. Thank you.

Assemble Stratco Handi-mate HM4 sliding door shed. 2.21X1.55 onto concrete slab(already poured).

EasyShed shed assembly in carport. Good access, clear area to work in, semi-covered.

Assembly of x2 easyshed narrow garden shed slider (2.25m x 0.78) temporary attached to grass/weed mat. We had assembled the panels for one shed. Picture of area shed to be placed

Admitting defeat on this shed assembly. Most of the annoying work is already done. Two side wall panels fully assembled. Rear wall assembled. One roof section assembled. Other roof section and doors partially started. Need someone experienced with sheds/panel assembly to finish putting it together and stand it up. Mainly just need assembly completed and stood up. Anchoring/silicone can be skipped if needed to keep costs down. Located in thomastown Please send reasonable offers.

Pergola to cover up the side wall way of the house

Looking for someone to: * Demolish and remove an existing brick fence/wall * Remove and dispose of all brick/rubble waste * Take away approximately 80 metres of old timber fencing already removed and stacked on site Job located in Reservoir VIC. Would prefer someone experienced with demolition and rubbish removal.

need a 2.60x1.95M shed assembled. https://www.lasoo.com.au/products/one-deal/1855280/giantz-garden-shed-outdoor-storage-260x195m-tool-sheds-workshop-house-shelter?gad_source=1&gad_campaignid=20377310575&gbraid=0AAAAAon1ppp3gSNHBb0y6vIPBqULdE1_5&gclid=CjwKCAiA3fnJBhAgEiwAyqmY5TUCYAybVnokW8EL1Of9ji_UB2irqMH0SYNVZmwZW7sTyt9sPs-jXxoCho0QAvD_BwE

Hi Airtaskers We need this Small unrepairable Pergola Knock down. To make room for a new garden bed area We will Get rid of the waste We are on a budget, so the confirm and final price is $200 only to complete this task We are located in Mernda Vic, needs to be finished By Sunday 22nd March. Airtaskers that can do for the asking price, please apply for the task.

Task: Identify and fix rain leakage from my pergola roof. During rain—especially heavy rain—water drips through the pergola and wets the alfresco/outdoor sitting area. I need someone to inspect the cause (e.g., blocked gutters, gaps in roofing sheets, flashing issues, sealant failure) and repair it. A general clean of the pergola roof and gutters is also required. What you’ll see in the photos: Water droplets forming under the pergola roof and dripping down into the sitting area. Scope of work: - Identify the source of the leak from pergola roof - Clean the pergola roof and gutters if needed - Apply repairs (seal gaps, fix flashing, clear blockages, etc.) - Test to ensure no dripping remains Access: Easy access from the backyard. Ladder required. Location: Mill Park, Melbourne Timing: Flexible, preferably within the next week.

Need someone experienced to install a shed - brand is easyshed. Model - Tall gable model ETG-2330 - Size: 2.25m width x 3m depth x 2.42m height

I would like to help you again

We are looking for an experienced demolition worker for a house renovation project in Preston, VIC. Scope of work: Demolish and remove all plaster (gyprock) from ceilings and walls Areas include: 3 bedrooms Kitchen Living room 1 bathroom 1 laundry Requirements: Proven experience in demolition work Must have own tools and equipment Public Liability Insurance is mandatory Reliable and able to work safely 📅 Start date: 29 January 📍 Location: Preston, VIC Please message with: Your experience Availability Confirmation of tools and insurance Looking to start immediately with the right person. Thanks! 💪

Repaint drive way & alfresco of house around 55 square metre total.

Assemble and place 2.08m x 0.97m Wheelie Bin EasyShed

Need shade cloth and tarp (already purchased) installed to already built pergola.

Installation of a 3m x 3m EasyShed garden shed on a concrete slab

Hi i need this bbq pulled apart and the rendered bricks knocked down. There is a skip on site allready