Find skilled builders in Blacktown

I'm looking for an installer who can install the garden shed from Easyshed on the concrete base. Shed details: 3m x 3.75m Gable Roof Garden Shed.

Install SHED PREMIER DD ABSCO 3.0X2.25M on existing slab

Need bit of help with pricing for the job. Roughly 15M Driveway and about 8M wide. Double garage concrete area going 7M roughly down then back into standard 4M including council section. Needed a guide in pricing for the concrete, how much rhe total cubic meter is of concrete needing ordered for concrete & pricing for getting the job done. Payment will be done with Amex. Please only respond if you can take amex as payment

2.400 m (W) x 6.000 m (L) x 2.700 m (H)

I’m looking for a handyman to: * Supply and replace my existing pergola roof sheets with polycarbonate sheets (minimum 0.8mm thickness). * Supply and replace two battens that are partially rotten. * Provide all necessary materials, including screws, fixings. The pergola area is approximately 5.3 m × 5 m. Please provide a quotation including materials (sheet style, thickness, and fixings) if the uploaded photos are clear enough. Otherwise, I’d prefer a site visit to provide a more accurate quote. Address can be provided upon request.

- Disassembly of current cream pool shed. - Assembly and installation of the provided green pool shed, which has already been purchased. - Shed will sit on concrete slab, up against wooden fence, with expensive pool filter system inside. Therefore, some waterproofing required. - width and depth measurements of both sheds are the same = 1.5m x 1.5m - New shed is taller at 1.8m - Brand: Easy Shed - Model: 1.5m x 1.5m Gable Roof Shed - mist green

I need a shed installed on a concrete slab

Approximately 2 metres in length, the ramp is for a car to drive over daily. Note: I do not have a ramp and require you to source and install.

We removed an old pergola and need help repairing and covering the wall area. Scope of work: Repair 2 large holes and several small holes Apply waterproofing Install timber slats (decorative battens) to cover the area Paint for outdoor protection Photos attached. Price is just a guide and can be negotiable – please quote your price for the full job (materials + labour included). Looking for someone experienced who can do a clean and neat job.

Installation of a 3.0m X 5.9m Stratco Shed on a concrete slab Concrete slab has a slight fall of about 100mm from left to right and fall to the back as well

Hi, Task 1 - Decking I need a handy man who can help us with our existing deck. Our deck is atleast 8 years old and it needs to be redone. The measurements of the deck are width - approx 6 mtrs length - 4 mtrs shape - its an L shaped deck with Merbau wood Task 2 We have a pergola with gutters for which we need a transparent roof. the exiting roof is 3 plastic sheets which has been joined and they are leaking water. pergola measurements are width 4 mtrs length 3.5 mtrs

Need a licensed tradie to provide and install motorised blinds for a pergola

Looking for someone to excavate a small amount of additional dirt from our driveway in preparation for some roadbase. We’re looking for someone who can create a neat edge and ensure the ground is level.

Need to remove old colorbond and timber. Need new timber and colorbond. The mud room needs an extension roof to put a screen door.

Just an assembly and anchoring done, already have the anchoring kit and shed parts delivered

Painting woodwork under the pergola area. Corrugated roofing is due to be upgraded so painting the beams does not need to be accurate as paint on the roof does not matter at this stage. Paint will be provided. Last guy was totally unreliable and did not show up multiple times and with no notice. We are looking for someone who can reliably complete this job.

Hi everyone, I need 2x pergolas to be cut back to reduce length by 30cm. 1 has colorbond roof 1 has polycarbonate.

I need help to finish the remaining easy shed build 3x3x2.4M. 1 back, 2 side, 1 roof panel is completed. Not much is left. Remaining- 1 roof, 1 front including door panel, and putting all panels together and making the shed. Timber Shed base is ready. I need this done as soon as possible.

Hi, I’m looking for an experienced person to install a steel shed that I have already purchased.

I bought a basic pergola kit and I need help putting it together. You will need to be able to drill holes into concrete to secure once built. Please see photo for area to build on Can send image of pergola