Hire a trusted stove installation and repair service in North East Melbourne

Two of the induction plates are not working so looking to replace or get them repaired. Need to check the oven if its working or not

I have two stove top burners (on the left) that will not stay alight on my Smeg freestanding oven. Also, when 2+ burners are on at the same time, the flames are weak. I’ve already had a technician come out to quote the job, so I already know what is required to be fixed. Gas pipe also needs to be replaced because it is dented in one section and reducing gas flow to the burners when oven is against the wall. Have already tested by pushing stove away from wall. Can I please be quoted for the below: 1. THERMOCOUPLE WOK BURNER [Front Left] 2. THERMOCOUPLE [Rear Left Burner] 3. GAS DISTRIBUTOR PIPE ASSEMBLY 4. Cost of labour I’ve been advised that the replacement of the thermocouple may not fix the problem, and if that’s the case, the wiring underneath the stove top may need to be replaced for those two burners. A quote for this would also be helpful. Thank you

1. Moving gas pipe from ground to the wall for oven and gas installation 2. Moving kitchen tap hold and colder water up to down to install sink 3. Put one electric point near gas stove 4. install and connect gas stove,5. install and connect oven 5 . install and connect rangehood 6. install sink 3. 1 electric switch on the wall for oven

Need to remove old cookers and install new one

One of the stove switch not working (looks like one of the switch has moved out of the place )

Shore up side and rear panels to make level, cement sheeting area to be tiled. tile floor area under stove, tile walls either side. Tile floor to rangehood behind stove. Stove has been removed for easy access. I have tiles, just need cement sheeting, glue, grout, spacers, sealant.

Smeg gas stovetop is not light flame on any of the heating units. You can hear gas being dispensed but no flame catches.

Gas Stove is not igniting. 3 out of 5 Oven fan bake mode not operating properly Open to offers

Looking for a licensend plumber to prepare our kitchen for demolition before our new IKEA kitchen is installed. * Disconnect the existing gas cooktop and safely cap/seal the gas line * Disconnect the kitchen sink and tapware * Disconnect the dishwasher (we are keeping the dishwasher, so it only needs to be disconnected and moved out of the way) I would like to have someone onsite this Saturday.

I need someone to come fix my stove cos, it's driving me nuts! I dont know who broke it (not me) or how it broke (maybe water) but the ignition on my gas hobs doesn't light them...we have to use a lighter and it's a pain in the ass! Also, one of the rings isnt getting any gas at all! So need that fixed too. Im told as its dealing with gas, i need a Licensed Gasfitter or a dual-certified Gas/Electrical Appliance Technician...so experts only please. I've just set the budget to cover call-out to suss out whats wrong. Once we know, happy to chat what it will cost ti fix it.

Looking for someone licensed for gasfitting to safely disconnect and remove an old gas stove. The stove is currently connected to the gas supply, so the gas line needs to be properly disconnected, capped/sealed, and checked to ensure there are no gas leaks.

I need to 1) check/repair gas on stove 2) repair window lock 2x to reopen window

Checking of gas stove And fitting

Checking the stove and fittings

Two out of the 5 gas burners not working properly One completely won’t work Other works but then you have to wait for it to cool down then only it works it struggles

Gas stove is not firing up. We need to fix it

Stovetop broke. New one is bigger. Need hole in composite stone enlarged

I need someone to disconnect and remove my existing gas stove in Mernda this Saturday.

Existing kitchen stovetop has sealant. Need this removed and new one applied.

Caulking around kitchen benchtop. White around the edge, clear around the sink and gas cooktop. Fairly flexible with date/time. Anytime after this weekend and before July 2 or so.