Find a professional staining service in South Melbourne

- Sanding deck (4m x 1.2m) - Replace 1 board - Replace 1 trim next to door (1.2m) - Staining deck. I’ll add a photo of the colour I would like it stained

As per photographs, our deck could do with a refresh, preferably two coats. It will require a few visits to allow for moving things to one side to stain and dry before moving things back onto freshly stained area. It’s about 5m x 5m and has three steps. 1. Pressure wash 2. Replace some lifting nails with special screws we’ll provide 3. There’s no need to move the large rectangular planter boxes, just reach under to stain, but will need to move smaller pots, table and kennel to one side of deck at a time to stain - we can help 4. Stain one side at a time using mop applicator AND a brush, the gaps between the boards are large enough that the inside edges need to be stained using a brush 5. Care is necessary to avoid drips, because our deck is over a common entrance where neighbours drive their cars in and out so we don’t want drips falling on their cars - we will warn them of timing 6. We have the stain and can buy more as required

Deep scratches on wood floor from moving furniture, possibly need help to restain/repair without having to replace floorboards, make it less noticeable

Sand and stain floorboards. Approx 100 sqm including 2 sets of stairs

Looking for someone to come and prepare, sand and stain a deck using sikkens products. Probably 3 coats for lasting protection!approximately 6m x 4m area including fence and built in bench seat

sand down 7 door fronts for our kitchen cabinetry (2 of which are tall pantry sized and the other 5 are shorter) and 4 of which for draws. They are solid timber and we are wanting to sand the top layer so we can stain them with a darker stain. Please also provide separate cost if we were to include staining

There is a stain and burnt section of carpet which needs to be replaced. We have a roll of the exact same carpet, so can be used to replace the damaged area. The apartment is being sold, so end result needs to good.

I am seeking a quote to stain my grey/worn front and rear covered veranda decks, each being long and narrow approx. 10sqm each - total 20sqm in a merbu/darker stain inc preparatory cleaning. Has raised done head nails.

Build 2 boxes 1.5m x 250mm wide x 200mm high using recycled timber and stained to suit

Looking for a skilled carpenter to supply and install 12mm MDF to stainless metal retail counter, bench top and counter top this weekend. Dimensions of work in attached image. The MDF will provide a substrate for porcelain stone installation. Work is for a cafe and due to hours of operation the ideal job time is: - Monday to Friday after 2pm - Saturday from 1 pm - Sunday all day

The stainless steel handrail came loose between the pole and bracket. Need to reweld and tighten all other poles.

Someone to come and glue back to stainless steel bench so could start using it again

Needing 6x dining chairs sanded and stained to match the lighter dining table. Happy to drop off chairs. - Due date: Before Sunday, 4 February 2024

Back deck needs cleaning, sanding and would like to stain in a long wearing dark charcoal colour. It gets a lot of sun. - Due date: Flexible

I have a wine tank lid that I need a 12" tri clover ferrule welded onto. It currently has a 4" one on there and that needs to be removed. The hole widened and the new ferrule welded on. The lid is removable from the tank. So I can bring it to your shop within 50KM. The lid is around 1.35mm thick and I have had no issues with the 4" weld that I have on there and it was done locally. - Due date: Before Friday, 27 October 2023