Find an experienced retaining wall contractor in WA

Concrete and post panel retaining wall twin side- approx 78m linear. Looking for supply and install of a concrete post and panel retaining wall on two sides totalling approximately 78 linear metres. Height will vary between approximately 0.6-0.9m Quotes must include: - materials - labour - excavation - proper drainage - footings - site clean up We will meet on site Wednesday 4/3/2026 to confirm scope before starting. Wall must be started by Friday 6/3/2026. Please provide: - Total all inclusive price - Estimated timeframe - Confirmation of what’s included - Photos of similar completed work -Advice if engineering or council approvals are required. Serious and experienced installers only please. Price written in the description is not final it is just because i cannot proceed without mentioning the price.

Small retaining wall to be painted. Happy for someone to call past to provide a quote

I’m looking for an engineer/designer who can produce retaining wall drawings and assist with council approval.

Need an engineer sign off on a pre cast retaining wall

Cement render small retaining wall - I will supply all the materials

Quote for 3 low retaining walls, supply and construct.

Limestone retaining wall is leaning. Block size is 500x350x250. Wall is 4 blocks high. It is leaning probably due to large trees which have all been removed now. Some blocks from top have fallen over as per pics. Need the wall repaired or replaced, I’d like to know what the options are.

“Front-loader washing machine. The rubber door seal is fine but the metal retaining wire with spring has popped off and needs to be refitted into the groove. Machine is accessible. No parts needed.”

We need to demolish 14m limestone retaining wall that is two courses high (500x350x200 blocks). Clean mortar off block and stack.

Drill some nails into wall so I can hang some features up

Will need proof of ability to complete the job please. I have a post and panel retaining wall i need done as soon as possible. I have done majority of the excavation, but will still need some more for the shorter side of the wall. Have beams ready to go into the ground. Requires 8x beams to have 600mm diameter x 2000mm deep concrete footings, the other 3x are shorter as per the gradient scale. Surveyor pegs are in place. Specific Information in pictures and can discuss on the phone, email or in person Cheers, Jake

There is a retaining wall on our property that is leaning onto our neighbour's land. I would like to request a quote for repairing the wall to ensure it is structurally safe. Thanks, Ehsan

Limestone retaining wall 2 x blocks high x 16 metres long (approx 64 blocks)has a couple of shallow corners. Blocks are 500x250x150 (blocks supplied)

We would like a retaining wall to be built in the backyard. It will replace the one already there which someone else will take down. Just need it built.

Looking to get retaining wall repaired.

Removal of hedge/shrubs on top of high retaining wall. Any roots will need to be poisoned. Green waste removed also.

Build panel and post retaining wall approx. 15 m x 2.1 m to meet requirements as shown on structural engineering drawings (available). This wall will support an existing patio wall that is gradually rotating outwards.

Repair an ageing limestone retaining wall (under 2m high) that has visible cracking and a slight lean of approx. 3–5 degrees (confirmed by a structural engineer). Scope of Work Required: Excavate soil/earth along the base of the affected section(s) of the retaining wall to expose the footing and relieve pressure on the leaning area. Reinforce and stabilise the wall, ideally using concrete or another appropriate structural method to strengthen the base and correct/minimise the lean. Address cracks and compromised limestone blocks where necessary (repair as required). Backfill and compact soil properly after reinforcement to ensure long-term stability and prevent further movement. Please provide a quote and estimated timeline, thank you

Need someone to render and paint this small brick section to match the rest of the wall (see photo). Please supply all materials, including render mix, paint, and tools. I don’t know the existing paint colour, so just paint the lower section to make it uniform (about 1 metre long) Access: Easy access from driveway/lawn area.

Need part of back wall rendered - after removing fence and realising it isn’t all covered (exposed brick) Once done wall will be painted and plants in front of it. After a cement render, made to look the same so that it looks decent when painted. Height - 1707mm By 4097mm length