Find a professional patio contractor in NSW

Looking for building a patio. With cool roof and decking 5x5 meters size

I am looking for 5x5 meters composite decking and insulated roofing .

Convert Queenslander room into covered terrace/patio. Ideally keep current roof, but open to complete rebuild if necessary

The back patio timber doors are sticking. I think planing/sanding a little bit off the bottom (and sealing them) will allow them to open freely

Roughly 30 sq m of mesh canvas roof to be replaced with polycarbonate

1. Cutting 3 bedroom Wooden Door Height by 5-8cms 2. Covering Small Patio Area with Corrugated Sheet: - Install corrugated sheets over a small patio area

Existing timber patio, requires replacement of some of the timber beams

The cabinet area is 57 cm wood and 86 cm high. It is a vacant space next to the BBQ, in our outdoor undercover patio. There was originally abar fridge in this space. My preference is not to replace the bar fridge there.

We recently renovated and got our patio sliding frame and doors replaced. The fitters took away the frame but were unable to take away the doors (due to company policy). The doors are unable to be collected at council pick up and are too long for our car to take them to the refuse collection point. Looking for someone to take them away. Can provide details of measurements if needed. They are glass with a metal frame.

Need handyman/landscaper to install Stratco outback patio in courtyard 3.8m by 2.4m attached to 3 side walls, no post required. There are 2 existing down pipes, might need divert or cut it out. Height around 2.5m from ground.

A patio with roof , heaters , fans Dimensions: 4.75 m x 4.1m x 3.4m (height)

Install a dog door on sliding patio door. I will need someone to inspect the sliding door and source the right product/dimensions from Bunnings. Will add price of product to cost of labour. Offer of $200 is labour only.

Remove patio sliding doors, framing and sills (for reinstall in another house) and transport about 1.5km. Do not need to reinstall, just deliver

I need a wall pushed back into a cavity, wall removed from kitchen and bathroom access door closed. Patio steps added. This needs on-site inspection and quote done

Need to draw up, design Woodfire oven section with a bench. Brick Base. Design only.

I have a six door timber with glass doors with outside frames to be installed in my patio. Please refer to the attached images. First image shows the doors and the frames, second image displays where they need to be installed.

Installation of patio kit

Installation of Stratco sanctuary patio kit as in image

Need supply and install of Perspex to outdoor patio. 5 panels roughly 1800mm x 160mm each

Needing an outdoor patio/annex installed using eps cool room sanwhich panels. Space roughly 5x4. Materials provided