Book a trusted oven repair and installation expert in New Farm

Remove old and install new electric oven. Install induction hob. This is replaces a gas hob so will need the dedicated circuit installing. At the back of the hob is the garage/laundry wall where the fuse box is located. See photo. The Fuse box has capacity. It will need approx 3-4m of appropriate cable to reach the hob. Will need to drill though wall to the kitchen the other side and install an isolation switch. There is a double socket at present on the splashback and hope to just swap that for a double socket with extra isolation switch, but no dramas if not possible. If you have a gas license too then include removal of gas hob as well. Otherwise I will find a gas fitter.

My smeg oven is no longer heating.

Oven and cooktop stopped working but all other appliances are working fine inside the unit. Might be a trip or electrical problem. Address: Moray St. New Farm

To replace electric oven (replacement supplied) plus replace gas hob with induction hob (also supplied). The induction hob will require wiring directly into the fuse box. The wall to the rear of the hob is adjacent to the garage where the fuse box is located. I propose new wiring to go through wall at rear of hob, then approx 3 m to fuse box, where there is an unused switch/fuse. The job would suit an electrician who is gas certified so could certify gas seal off. Also between removal of gas hob and installation of new hob , the currently rounded corners of the work bench cut it will require making into 99 deg corners. So two attendances at site will be required. Understandably this will increase cost.

Oven door is out of line and needs to be realigned/fixed I think it is just adjusting the screws on the door. When you try to close it is stays ajar unless you force close and push down into place.

Built in microwave top element is loose. Cannot reattach nut

ILVE oven the handle has come off on one side of the door, the nut it screws into has fallen into door, need to get it out to reconnect the handle

I have a Toyota Landcruiser 200 that needs a ProVent Oil Catch Can installed please. I already have the catch can 👍 Flexible on dates- cheers

I have replaced my oven and the current power cable isn’t thick enough or long enough. I need it replaced and the oven connected. My understanding is that it has a 4mm cable currently.

We are in planning of renovating the kitchen and need to uninstall the white goods from the kitchen.

We have a 6 burner natural gas stove with a gas oven under the stove, brand is gasmax. The pilot burner for the oven is not working usually we would have to hold it for 10sec before turning it on and recently we would have to hold it for over 3 or 4 minutes before it would hold the pilot flame now it’s not holding it at all. Need someone to fix this today please 👍🏽👍🏽 - Due date: Before Sunday, 31 December 2023