Find a local Tasker to help you make a kitchen cabinet in Outer South West Sydney

I already have a standard 600mm dishwasher and have had a power point installed. The existing cupboard opening is approximately 570mm wide internally. I need the cabinetry modified to create enough clearance for the dishwasher. The side panels currently support the neighbouring cupboard shelves, so I’m looking for someone experienced with kitchen cabinetry who can assess the best way to widen the opening while keeping the adjoining cupboards properly supported and finished neatly. Dishwasher is already on site. Looking for cabinet modification only, plumbing/ and power connection have been arranged separately.

Kitchen cabinet doors need replacing, cupboards and drawers - entire kitchen (not replacing cupboard structures)

Have a couple of small chips in my kitchen cabinet cupboards that I would like repaired.

Need to make kitchen 1x floor cabinets with drawers 2x wall cabinets Cabinet inserts with drawers and shlves

Modifying the cabinetry under the sink to create a suitable opening for the dishwasher. I’m not entirely sure about the plumbing, but I’d like to install the dishwasher immediately to the left of the kitchen sink. I’m assuming the existing water supply for the sink can be used to connect the dishwasher. As for the power, there is currently a power point above the kitchen benchtop. However, I would need a power point installed underneath the benchtop, inside the cabinet, which would be approximately 8 inches lower than the existing one.

I want to install a new dishwasher. Kitchen never had one. Looking at getting a Bosch Series 6 45cm Built-under Dishwasher SPU6IMS01A with the following dimensions 45cm width, 82cm height and 57cm depth. Will need to remove/modify the existing cabinet area shown in picture with blue circle. Bench/cabinet dimensions: 72cm wide, 86cm height and 58.5cm depth. Will also need to make for a path for the dishwashers water/drainage pipes to connect under the kitchen sink.

I need 25 cabinet doors and drawers replaced with new ones

need a few looked at and this one fixed up

Need to make new cabinet and install range hood underneath. I will buy and provide range hood o

Fridge cavity in kitchen has a cabinet at top which needs to be resized

I need an experienced kitchen installer urgently. Location: Rosemeadow NSW Work required: - Visit my home and take measurements - Supply and install upper kitchen cabinets (MDF, white) - Cabinets to reach ceiling (no gaps) - Space for 60cm rangehood above stove - Space for microwave Requirements: - Fixed price (including materials + installation) - Free measurement and quote - Must be experienced Timeframe: - Ready to start immediately - Prefer ASAP (today or tomorrow) - Job to be done in 1–2 days Please send: - Price - Availability - Previous work photos I am ready to proceed

Need to add a few more cabinets to the existing cabinets in the kitchen

Hi, I need a repair quote for my kitchen cabinet door/drawer. The laminate/thermofoil on the cabinet door has peeled off along the edges, exposing the brown MDF/particle board underneath. The peeling is happening vertically along the side and top edge of the door. The internal board is still structurally intact, but the surface finish has lifted and continues to come off. I want this to be repaired

Kitchen cabinet installation total 7 cabinets 3 bottom 4 top cabinet Install Bulk head and kik board customer supply all cabinets

Carpenter required to adjust the kitchen cabinets to install a dishwasher.

Looking for an experienced tradesman for kitchen cabinet & drawers doors, outside (not benchtop) paint job (polyurethane finish). The job is in Minto 2566.

Need kitchen cabinet extended. Supply and install. For liquor display.

Kitchen cabinet making and installing

New oven does not quite fit existing built in hole to allow door to open. Think it needs either fillers installed to bring oven forward or cabinet height extended around 5mm

Install 3 x kitchen cabinets, everything is in place and ready to be lifted onto the base and screwed in,