Find a local Tasker to help you make a kitchen cabinet in Inner West Sydney

Need two kitchen cabinet corner doors reattached to a kitchen cabinet. One door may have a faulty hinge. The existing hinges are full-overlay, wide-angle (approximately 170° opening). We have the original hinges available, but please bring compatible replacement hinges in case one needs replacing. Looking for someone experienced with cabinet hinge adjustment and installation.

I’m looking for an experienced cabinet maker or carpenter to modify the existing cabinetry in a granny flat kitchenette to integrate a standard 600mm front-load washing machine into the lower cabinets.

13 cabinets installed and a benchtop.

Looking for an experienced cabinet maker or kitchen installer to replace all kitchen cabinet doors, drawer fronts and filler/end panels. I will supply: * New doors * New drawer fronts * New filler/end panels You will need to: * Remove old doors and drawer fronts * Reuse and fit existing hinges and handles * Install and align all new fronts * Replace filler/end panels * Dispose of old doors and rubbish * Leave the kitchen clean Please only quote if you have experience installing kitchen cabinetry. Photos attached. Fixed-price quotes preferred.

Hi, I require x2 cabinet doors to be made with pre drilled hinge holes. Dimension: 730 x 393 x 18mm Colour: curl birch natural finish. Thanks

Update kitchen island with drawers and rubbish bin drawer to match existing kitchen. I have no idea on how much this job would cost, so am looking for competitive quotes.

Hi there Need a tasker to help fix one kitchen cabinet hinge. Always comes loose even after tightening the screws. Thanks

Our kitchen cabinetry under the sink houses a hot water tank. The tank developed a slow leak, which unfortunately went unnoticed until our neighbours advised us that water was leaking into the unit below. The leak has now been fully repaired, however the bottom/base of the cabinet has sustained water damage and is likely rotten. We are looking for a suitably skilled person (cabinet maker / carpenter / handyman) to: • Remove and replace the damaged bottom cabinetry/flooring only. We will arrange a plumber separately to remove hot water tank. - Repair the silicone between wall and stone benchtop where a gap has appeared in same area where the leak was previously The cabinet doors and upper cabinetry are in good condition and do not need replacing — it’s just the base/floor panel inside the cabinet. Bottom cabinetry measurement is in one of the photos

Bottom cabinet panel next to the fridge has swollen due to a fridge leak and needs repair or replacement. The damaged bottom panel appears to be semi attached (possibly glued) to the larger panel sitting above it. Kitchen is IKEA. Please see photos for details.

Front door is broken and needs to be fixed

The kitchen cabinet won’t close flush, and I suspect it’s a hinge issue.

Kitchen cupboard has randomly stopped closing. I think there is an issue with the hinges but not 100% sure.

Need one kitchen cabinet door installed which was removed while installing rangehood. Cabinet door and hinges are available.

We need assistance with the following: - screw a corner kitchen cupboard door back on its hinges - screw a sliding cabinet hinge back on a pantry door

Need to install panel on the top of existing bulkhead above kitchen cabinetry (see brown section in photo). The brown strip dimensions approx. 5m x 0.15m. No painting needed. I will be supplying the panel but you will need to cut to measure.

Our kitchen cabinetry under the sink houses a hot water tank. The tank developed a slow leak, which unfortunately went unnoticed until our neighbours advised us that water was leaking into the unit below. The leak has now been fully repaired, however the bottom/base of the cabinet has sustained water damage and is likely rotten. We are looking for a suitably skilled person (cabinet maker / carpenter / handyman / plumber + carpenter combo) to: • Temporarily remove the hot water tank to allow access • Remove and replace the damaged bottom cabinetry/flooring only • Reinstall the hot water tank once repairs are complete The cabinet doors and upper cabinetry are in good condition and do not need replacing — it’s just the base/floor panel inside the cabinet.

I need a cabinet maker / kitchen joiner (qualified with ABN) to inspect and provide a written quote for the removal and replacement of ground-level kitchen cabinetry only. The existing base cabinets have water staining, swelling and warping due to prolonged moisture exposure. The work required is replacement, not cosmetic repair. No upgrades or redesign are required. Scope (for quoting purposes): Ground / base cabinets only No overhead cabinets No benchtop, appliances or plumbing changes Like-for-like replacement (no betterment) This quote is required for insurance / strata / legal purposes, so clarity on scope and cost is important. 📍 Location: Ground-floor unit, Croydon Park (Inner West Sydney) 🕒 Timing: Inspection and quote required within 1–3 days. I’m available most hours. Please advise: availability for inspection whether you charge a call-out fee (and if it’s deductible from the job if accepted)

I have a two‑piece corner cupboard door with a hinged connector between the panels. The connector hinge is now working, but the main door still won’t sit straight when closing. A new hinge was purchased and we attempted installation, but it did not solve the issue. I need someone experienced with kitchen cabinetry to diagnose the problem and adjust or re‑mount the hinges so the door closes properly.

Adjust a couple of kitchen cabinet doors. I think I need a new hinge on one as the adjusting screw seems to have broken. So please bring the replacement hinge as pictured (additional payment for parts). Thanks.

Need to fit pull out racks seemlessly integrated with the existing doors