Find a professional gate installation in Outer West Sydney

Looking for an experienced fencing installer to install a black aluminium slat fence and gates. Scope of work: * Mark fence line and ensure boundaries are straight and accurate. * Dig 23 post holes (600 mm deep). * Install aluminium fence panels and gates. * Concrete all inground posts. * Core drill 3 posts into existing concrete. * Cut aluminium posts to the correct height where required (bring your own aluminium cutting/drop saw). * Ensure gates are aligned, level, and operate smoothly. * Clean up the site after completion. Materials supplied: * Aluminium fence panels, posts, gates, screws, and accessories. * Concrete bags. You need to bring: * Post hole digger/auger. * Core drilling equipment. * Aluminium cutting saw. * All standard fencing tools and PPE. Requirements: * Proven experience installing aluminium/slat fencing. * Ability to accurately set out fence lines and levels. * Own tools and transport. * Please include photos of previous fencing work in your offer. Looking for someone who has done similar aluminium fence installations before and can complete the job to a high standard.

Cut and re weld tailgate hinge

Looking for an experienced handyman to repair a timber rear service gate at our hotel. The gate is located in the hotel car park and provides access to the linen storage room. The timber gate post has broken, causing the gate to fall. We are looking for the most cost-effective repair. If the existing post can be repaired or reinforced safely, we would prefer that over a full replacement. The gate needs to be secure and open/close properly for staff access. Please provide your best recommendation based on the attached photos and advise if any materials are required. Flexible budget. Photos attached.

New front door lock and handle and new driveway gate lock as it has been broken

I have wooden pieces attached to side of my house. I want to replace it with colorbond gate to give access to my backyard. I need someone to bring and install new/used colorbond gate and removed wooden piece

Complete installation of automatic kenner gate opener including power box installation

Install 20m of colorbond fence, 1.8m height at the back yard and 10.5m of 1.2m height monument color alum horizontal slat fence at the front, and 2 single gates, one on the front and the other on the back yard. Please quote based on cost per meter.

Fenstar aluminium slat pedestrian gate with 2 posts to be assembled and installed at side of the house. Width 1240mm, height 1800mm.

Install a farm gate. Dig post holes, concrete in posts and mount gate in driveway.

Install magna latch pull gate lock

Need this installed onto door frame as per instruction booklet and photos. Drill needed!

Install a new colourbond dbl gate as the current one has dropped and not done well , fix and reinforce 3 -4 fence panels and posts on side fence

Supply and Installation of an Aluminium Slat Gate, Manument, 10mm gap, H:1800mm, W:855mm

Supply and installing of approximately 98 Lineal Metres of 2.1m Black Spear Top Fencing About 34 LM of fencing will require 1 timber sleeper underneath 2x 6m sliding gates complete with track , motor and sensor. Job is ready to go at South Windsor.

1. Demolish existing wooden door (no need to take away); and 2. Construct two colorbond doors and side fence in red (total area width 2100 * height 1900).

I have two posts, one gate, two top rails, two bottom rails and one sheet of colour bond. I need one gate and one sheet of fencing installed.

Install gate for stairs. Werrington

Convert existing Colorbond side gate (145 cm) into a double swing gate: 50 cm + 95 cm. Manual gate, wall‑mounted hinges into brick walls. OK with modifying existing gate OR installing two new leaves. Need hinges, latch + drop bolt fitted. Budget is for labour only.

Can’t get the gate to work. Has power. It is a beninca turbo. Intercom has no power idk if that is the issue.

Old corrigated shed roof needs holes repaired