Find a professional gate installation in Mernda

We have a front gate with a soon to be installed sliding gate, need to run power to it. The driveway and sliding gate are on the right and the electrical box is on the opposite side of the house. The only thing is a concrete path obstructing any cabling that needs to be run through as well as underground water pipes (the position where the power will be located for the sliding gate is close to the front water tap) Not sure if low voltage is required instead, just mindful that the sliding speed will be too slow. I’ve attached a photo of the front of our yard before our existing gate. The left is the position we want the power. The circle is the pathway that is an obstruction. And the X on the right is where the box is located. How long and how much! Have to be qualified.

I need someone who welds to fix this gate. The hinge pin is stuck in the hinge frame itself and cannot turn. The full hinge may need replaced. I am not concerned about having to paint a new one but if it’s replaced I want it matching the top hinge.

Looking for someone to build me a gate here instead of this fence. I want it to be the same height as the fence. Be able to put a lock on it.

I need a fence / gate to be installed. The gate should be where the rubber pathway is, so that it can be opened. Welcome to do a site inspection. Rough estimate of length would be 6 - 8 m. Posts will have to be dug in 3 types of surface. The composure of each surface is: - Artificial turf -> Soft Rubber -> Concrete - Artificial turf -> Soft Rubber -> Dirt - Mulch -> Dirt

Timber pickets on gates removed and replaced. I will supply pickets. Not sure how easy/hard screws will come out as been painted a few times

Remove old pickets and replace new timber pickets on steel framed gates. Latch will also have to be re-installed. I will supply pickets. Not sure how hard/easy screws will be to remove as been painted over few times.

Remove and replace timber pickets on steel framed gates. Also latch. I will purchase new pickets. Not sure how easy or had existing screws will be to remove as had few coats of paint.

Remove & replace timber pickets on gates, I will supply new pickets. Not sure how easy screws in existing pickets will be to remove as gates quite old. Gates have a metal frame. There are 30 pickets and latch will also have to be removed and replaced

The back lower gate of my trailer has come off. I need this repaired

I have around 4 meters colorbond fence at the front. I need to add a colorbond gate around 800mm width. Location Mernda, easy access, flexible time.

Install digital gate lock to wooden gate

Just moved into house and can’t find a handyman to fix our gate. The left side is up and stable but the right side doesn’t have a post that is holding up the gate.

Need to check mechanism on the gate. As it’s not opening or closing properly.

I need automated Fencing for my driveway and between my home & neighbours property. Also would like an entrance gate.

Need existing fence turned into a gate to swing outwards of the property the 2 panels in the photo to swing outwards - Due date: Flexible

Hi All, We are needing our double colour bond gate replaced please. We had a car accidentally go through it and we need it replaced to keep our backyard secure. Feel free to msg any questions you may have I have included a picture as well. Happy to provide address to come out and give a quote. Hoping I can get the job completed before the 15th of December Cheers - Due date: Before Friday, 15 December 2023

Prepare and Oil Deck & Benches and Side Gates Two coats to be applied. Decks in good condition. Prepare the Deck: Sweep the surfaces to get rid of dust and dirt Clean the Deck using Cabots Deck Clean and scrub.Leave the solution for 10–20 minutes, Rinse off the surface with water using a pressure washer Apply the oil following the grain of timber. Apply a second coat after the first one dries Decking oil n Cabots Clean will be provided. U will need to have other tools - Due date: Before Thursday, 16 November 2023

Installation of 1 small and about 1 metre front timber side gates - Due date: Flexible

A car ran through our double colour bond gate and we are needing this fixed asap as we need to keep our back yard secured not sure how much this is going to cost hense I’ve just put in the minimum price - Due date: Flexible

Need a carpenter to supply and install timber look aluminium gate with a lock, approximate measurement: 84 cm width - Due date: Needs to be done on Saturday, 11 March 2023