Find a professional gate installation in East Brisbane

We have had our gates damaged, we have new gates, but need the post reinstalled and the gate fitted

I need a black powder-coated pool-style gate installed across a 1180mm opening between two walls (see photo). It’s for a kids area, so it needs to be safe, secure, and self-closing. Requirements: • Black powder-coated finish preferred • Gate needs to be securely mounted to both walls • Self-closing with child-safe latch (like a MagnaLatch or similar) • Installer to supply gate, posts (if needed), and all fixings Wall fixings should be tidy. Located in Victoria Point

Install a baby/pet gate in hallway. Will require some wood either side to secure it to wall.

Hey guys I have just had a new driveway laid and it has raised up a bit in the section with my twin ally gates. I need the hinges moved up and alligned.

I need assistance fixing the alignment of a double gate fence door.

We would like an aluminum gate installed at the front of our property. No fencing is required. The width is about 1470mm and height 1800mm. Attached is a photo of the entry way we would like the gate across .

Wooden gate needs rehanging because of broken hinges

I have a few issues with some posts on my side fence adjoining a park

Required gate latch fixed back on ,couple of bolts .Simple job

Screw 6 merbau boardsu onto a steel gate. I will supply the boards. I am located in tingalpa

Side gate installation. Approx 1.5m. Prefer aluminium.

Installation of 12 m of colorbond fence panels, installation of hinged security gate, installation of security fence panel (approx 6m including hi ged gate) and installation of telescopic sledding security gate kit

I need to get installed an aluminum slat gate with posts. The area is 3.95m wide and 1.8m high. Gate needs to be 2 parts with a lock in the center and a ground bolt. The slats should be vertical without any gaps. The gate frame and slats need to be in dark cream colour. Need it done by the end of next month or so.

As I reversed my car this snap need to be put back together

Hi, Need a gate installed on side of new house. Will need to check measurements first.

Replace a wood gate about 83cm*82cm

I have a 1.2m wide x 1.8m high aluminium slatted gate that needs to be hung on the post that has already been installed. Unfortunately the contractor who installed the post put it in the wrong position and I have had to purchase another post that needs to be attached to the corner of my unit, so that the gate will close. I also have 6 sheets of corrugated colorbond each 2.4 m long that need to be attached width wise to the length of my side fence so my cat can’t use her claws to jump the fence. I have all the supplies needed.

We have a second hand metal and timber gate that we would like painted and installed to our driveway. We would also like a motor installed to allow it to slide electronically. We have a metal bar installed for this style gate (see picture)

I have a side timber gate that’s quite old. Need it replaced with a new one and new post.

Need to side access gate made and installed down the left side of our house. One side can be anchored to the timber fence and the other to the brick in the side of the house. The space is 90cm wide. Will need to have limited space underneath it so the dogs cannot get under it. Am open to ideas on style and materials.