Find a local floorboard profesional in South East Perth

Require someone to assist with finding a new floor board to match the remaining floors and install in the doorway

The following works - Install three new laminate planks. The planks must bbe cut accurately around a curved step. (planks supplied) - Replace one laminate plank in kitchen (Planks supplied) - Replace 8m of scotia in kitchen (no material provided) -

Need three small holes repaired on our Marri floor boards

No more gaps between tiles and skirting board. Have all materials required.

Remove 50 square metres and 16 stairs of tongue and groove timber flooring glued to ply from concrete slab. Also remove skirting. Flooring and skirting is spread over two levels. Needs to be cleared to concrete slab to tile on. Don’t need to remove rubbish.

Installation floor boards

Skirting boards laid throughout house

Remove hardwood skirting boards without damaging plaster walls. Skirting boards are being reused so keeping them intact as possible. Jarrah floor boards have already been removed so only floor joists remain. De-nail any remaining nails from joists. Loose-lay plywood approx 50m2 over jarrah joists to provide a working platform. House is 2 bedroom and open living space approx 50m2 of floor area. Person needs own tools and PPE

A couple of small areas/ scratches that need to be repaired (sand and revarnish). Need done asap.

Replace 3-4 existing jarrah floorboards (85 × 19mm) and laquer / finish to blend in with adjacent existing floorboards.

Skirting board install to new single storey home with hybrid laminate flooring.

De-nail jarrah floorboards Remove old nails from old floorboards To prevent ‘exit wounds’ on the dressed/smooth side of floorboards they need to be pulled from the underside using pliers. I have approx 80off floorboards with 10off nails in each board (average… some more, some less). That’s 800off nails. It take less than 10sec each nail… more stubborn ones maybe 20 seconds. So average 15 seconds each. So that’s 1200 seconds to do the lot (or 80 minutes or 1 hr 20 mins). Sometimes the nails snap off and need to use a nail punch to knock them through… allow additional 20 minutes for this. When the board is complete I need them stacked neatly on a pallet… allow additional 20 minutes for this. That’s a total of 2 hours.. I reckon it will take 2 - 3 hours to complete this. I have bought new pliers for this job and they work great.

We require approximately 23m2 of recycled jarrah floorboards installed directly to concrete floor. We would like these sanded and polished if possible also. 30m2 jarrah supplied. Job ready to start immediately. Thanks

Need to replace existing carpet and install laminate floor board. The size of the master bedroom and WIR is 17 m2. I would like the cost estimate.

I want to install 140m of skirting boards on my 4x2 house

Seeking someone to remove the skirting boards (keeping these), plus carpet removal and disposal. Approx 50-55sqm, 2 bedroom apartment in Lathlain. Upper level with elevator access. I pick up the keys June 11th, Tuesday midday and looking to get this done asap before I install new flooring. Some old real estate photos attached + basic floor plan.

Fix the laminate board in the master bedroom. Only a couple of boards near the wall needs replacing as it was damaged by water leakage. Boards will be supplied. Thanks

Supply and nst skirting boards

Lay laminate floor in a hallway, have supplies.