Find an experienced floor repair pro in Sunshine Coast

The laminated flooring in a couple of rooms has damaged and/removed. I am locating a similar product. I am not sure of the value of this work so just put $10 to create the job.

Repair deck and then clean and stain it.

Repair 3x Timber knotholes in decking - see photos attached for sizing. Repair/ fill in needs to withstand high foot traffic area and allow for thermal expansion/contraction.

I have some rotted deck boards I want to replace. I have bought 27 secondhand boards that measure 3.5m in length, ready to lay to replace some old rotted ones. I can get the correct decking screws, I have some tools & I have a drill however your own drill would be great as mine is quite old. The deck is only 30cm off the ground, so when you pull the boards up you can stand on the ground easily. I’m hoping to get someone before the 31/10/26 to fix the deck @ $50 per hour

Timber deck needs sanding and staining. Stain will be provided. Timber deck has screws not nails. Bamboo will need to taken down and new panels (I will have here ready to install) And timber in between bamboo needs to sanded and stained.

Flooring join has been scratched out by dogs and requires repairing. Cork type wood. Thankyou

A section of hybrid floor that is split and spongey. We have few boards that can be used as a replacement

Burned charcoal from the fireplace accidentally fell onto the hybrid flooring, resulting in a visible burn mark.

We redid our bathroom which has lead to a hole in our bathroom floor. I don’t know if it is possible but I am looking for someone who can fix it.

I have bamboo flooring throughout most of house. Finishing at edges has not been done and there are a number of gaps near skirting etc that need to be finished off. Also have some minor damage to some boards which need repair or replacement. Examples in photos attached.

Repair flooring installation. Floors installed 3 years ago with SPC “Coastal Limed Oak” and now the stairs are cracking.

Previous housemates left gouges in polyurethane coated floorboards. Floor boards also show signs of scuffs and scratches from every day use and dogs. Main concern is the gouges second concern is overall buff or polish. *Do not have permission to sand anything back (nor the funds) just want to take the attention off so when property manager inspect, they don’t pick up on it I would be open to sanding the affected floorboards for the deep gouges. But cannot do a full sand and polish of all floorboards. I believe we have the original vanish, but this would be quite old by now so not sure if the sheen or colour will match any more I have tried wax sticks, scratch polish, walnut. My next attempt was going to be to hire a floor polisher however KENNARDS hire company did not recommend their floor polisher for our job. They expressed that the provided pads will not suffice. Every specialist I speak to says that they will not just sand one area due to the potential of mismatch I am open to advice, and happy to assist

A large fridge was moved over the laminate floor and left some deep scratches. This needs to get patched up for the real estate. Looking for quotes at the moment. Thank you.

We have a beautiful ground floor rear deck that was built with the Hardideck, cement sheet decking system. An area of the deck has weathered and some boards have been damaged. They basically have holes in them. We need to replace the boards and probably redo one area of the deck. The frame is excellent so it is perfect for someone that understands how easy it is to install the hardideck product. You will also need to prime and paint the area. We have all the product so we are looking at labour. Attached are some photos. We are looking for someone that takes pride in their work. The replacement area for total board replacement is approximate 3.5 m x 4 metres. Then just some care to the other area.

Water damage needing floors repaired

I need about 5 weatherboards replaced and about 12 fixed. I have sourced paint and would need the high ones painted

Scratches on vinyl flooring repaired

Description: We had a slow water leak under our dishwasher which caused the spotted gum solid timber floorboards underneath to swell and buckle. I’ve already removed two short sections (~59cm long each) that were badly buckled (I have photos of before removal + the removed boards). The underside of the removed boards shows construction adhesive, so this looks like a glued-down floorboard patch repair (careful cutting/fitting to keep everything flush). It’s possible 1–2 adjacent boards will also need replacing once the dishwasher is pulled out and the area is inspected. What I need done: Pull dishwasher out for access (it’s plug-in power, not hardwired) Disconnect/reconnect standard water inlet + drain hose as required Inspect and confirm which boards need replacement (expect 2–4 short sections) Cut, fit and secure replacement spotted gum sections to match existing (flush and stable) No sanding, staining or coating required Reinstall dishwasher ( with driptray if I can source one ) and check it sits correctly and runs without leaks. Materials: I have suitable spotted gum timber lengths for replacement pieces. Please bring tools + consumables (adhesive, fixings, blades, etc.). If you’d rather I buy adhesive/fixings, tell me exactly what to purchase. Notes: Please quote with the assumption it may be 2 boards, but allow for 3–4 if needed. Photos: removed boards + cavity area before I removed the boards ( the removed boards are the buckled ones in the middle ).

repair water damaged polished concrete floor

I few hybrid floor boards have raised and need to be re connected. We believe it is tongue and groove system.