Find experienced local fencing contractors in West Pennant Hills

I have purchased fenstar DIY gate kit from Supergates Automation and Fencing and require installation. This is for 2 gates. 2.3meters wide. one gate will need posts dug and cemented into ground. the otherside will need the post bolted into existing concrete. https://supergates.com.au/product/hamptons-by-fenstar-double-gate-kit/?attribute_size=1200mm+W+x+1800mm+H+x+2+%28suit+2460mm+Opening%29

We need a swing gate installed. Nothing fancy as we are just going to use it close it when our dog is outside and make sure she doesn't run outside. It's about 330 cms wide may be

Small section of a timber boundary fence requires support by one or more support posts as it is leaning over. The existing steel support post has become uncoupled from the fence. This post will need to be raised to couple with the fence section and then reset into the ground. The job may possibly require another similar post to be added for strengthening, to ensure the same thing doesn't happen again.

Supply and Insta Perspex panels to top of pool to make it compliant

Old timber fence falling in some areas that requires new palings and reinforcement to straighten and make it more sturdy.

Install bird nest for solar panel. 12 panels - Approximately 15 m Circumference. I have already purchased the nest and clips. Please quote to install only.

hi, can someone please install 2x colorbond gates (monument) for me gate 1- 1.6m wide gate 2- 1.2m wide double sided lock please

2400mm wide x 1800mm high section of existing Colorbond fence damaged by wind and a falling tree. All vertical fence posts still good and solid, and would like to re-use most of the panels if possible. Seem to be readily available at Bunnings(Colour- Pale Eucalypt). However top and bottom rails completely twisted and need to be replaced. Don’t care how it looks, just want to keep the cost down and make it safe again.

Couple of Posts in my Fence with neighbour are leaning,

I need the current fence height extension panel to be extended all the way per photo.

I have about 20 holes in Brushwood Fencing that I need patched. The holes are caused from dogs and foxes. I need the holes patched with brushwood or alternative. The Patch only needs to last about 12 months until the entire fence is replaced. Attached are some example photos. Job in West Pennant Hills

Side gate to a free-standing house. We need to replace a pool fence magnetic latch. The latch will be supplied by the house's owner.

Do need to fabricate frame to install a gate for 2.2m section.

My pool fence railing has been sawed off and needs to be repaired. All the doors are intact, but the support posts have been sawed through.

Have an existing timber fence. 35 meters long You can use the posts and rails.

Seeking a wooden boundary fence. Height must be 1.9 to 2m.

Fence is leaning after strong winds, see photo attached. Need to repair with 4 steel posts to strengthen it up.

Replace existing aluminium fence and install taller fence (to prevent dog from escaping) Approx width 105cm x 160cm height

The yard fence, the retaining wall near the gate, and part of the garden wall need repairs.

Need to fix off new 3metre rolls of brushwood to face of existing structure. Secure/tie off to posts and strained wire and install capping.