Find a local electronics repairer in City West Campus

Red light flashing and beep and wont heat

My ghd hair iron made a pop while I was using it and stopped working. It’s out of warranty can it be repaired please.

Fagor EVO-CONCEPT CO-402BDD. The commercial glass washer keeps filling water. When I open the lid or switch off, it stops filling.

Need foxtel box set up. Need wifi looked up (Telstra). Need apps put on 2 TVs

Hi, I’m looking for a skilled carpenter / joiner / cabinet maker to design and build a custom front table / counter for my market stall. I’ve attached a reference image to show the general look and style I’m aiming for (modern, timber and black, clean and professional), but this needs to be purpose-built for real market use rather than decorative furniture. The table needs to be collapsible or modular so it can be packed down and transported easily. It must be lightweight enough to move, but strong and stable enough to comfortably hold a pie warmer and basic service equipment — it cannot be flimsy. Minimum depth required is 50cm. Total length will be approximately 2–3 metres, and I’m open to advice on the best modular layout. It will be freestanding inside a marquee and needs to sit level on uneven ground. Materials would ideally be timber (or timber-look panels) with black structural elements, finished cleanly and professionally for food market use. The front panel should allow for a logo to be added later (likely an acrylic sign). I’m open to modular sections rather than one long piece, and I’ll need space for staff entry/exit at one end. Happy to collaborate on practical improvements — function is just as important as aesthetics. Please include any relevant experience or photos of similar work, a rough price range, estimated build time, and any suggestions you think would improve the design. Thanks, and I look forward to working with the right person.

Needing black rubber mats removed off the stairs and thick adhesive under neath removed so I can paint the stairs

I have various lamps that I need to have professionally rewired to Australian plugs, in compliance with AUS safety standards etc. They need to be professionally completed and tagged in order for me to legally sell them in my shop, so I am requiring a licensed electrician for this task. Lamps range from table lamps to floor lamps. All imported from Denmark. Budget: $50 - $80 per lamp.

My puppy has chewed through the power cord of GHD hair straighteners so i need the cord replaced.