Find screen door repair professionals in QLD

Our front Crimsafe/fly screen security door has come off and needs to be refitted. Looking for someone experienced with security screen doors to: • Refit and realign the door • Repair or replace hinges/fittings if required • Make sure it opens, closes and locks properly again Please bring the necessary tools

Damage on wardrobe door, wall and door needs repairs.

Shave/trim 4 doors to allow for the new carpet.(approx 2 to 3mm) Replace door knobs with lockable door knoba for 3 doors Check that all doors open and close properly

Some of security doors at my place needs new rollers and locks

Shop front door hard to open, may be need to replace hydrolic cylinders inside. After Site inspection , need quote.

I have some lightweight Aluminium sliding doors not staying on tracks. I have 2 sliding doors in the apartment. One of them comes off the rails with a simple gust of wind. I think perhaps they need new rollers. Could you please provide a quote to fix. Thank you

Need quotes to get this door fixed

Tear in sliding wardrobe door that goes through both sides. About 6cm in length. Needs to be patched and painted please. In Milton, Brisbane

Hi, we need help repairing this door (see photo) at our small office. We had a new floor installed and as a consequence the door can no longer close. It needs to be shaved down a little and then reinstalled.

Hole in door repair, caused by soccer ball. Need hole repaired, sanded and painted as necessary. If can’t match paint, request entire side painted. Unsure of how best to repair but open to suggestions.

Door Repair • can provide chip for colour match • wood needs to be infilled if possible

Garage door repair， cant lift up

Have new fly screen to put on front door and back door have all the tools cutter roller ect

Door needs repair. Glue the broken parts in and fill gaps. Once cured it needs sanding and then stain + seal.

Looking for an experienced carpenter or sliding door specialist to repair double cavity sliding wardrobe doors please. The doors are significantly misaligned and leaving a large gap in the centre when closed. The issue appears to be related to worn or failed rollers, hanger hardware, or track alignment. Seeking someone experienced specifically with cavity sliding door systems who can: • inspect and diagnose the issue • supply any required rollers or hardware • realign and repair the doors properly Photos attached. Please quote for diagnosis and repair together where possible. I am looking for someone who can efficiently inspect, identify the issue, supply required hardware, and complete the repair without unnecessary additional call out visits. As I have a new born baby.

Looking for quotes to fix a stiff sliding door. We’ve just moved in this house and the sliding door has seen better days. Unsure what’s going on with it, if it’s the track itself but it’s stiff when sliding and gets a bit stuck half way then continues. Tried cleaning the tracks and WD40 and it’s helped but it looks like it’s scrapes the tracks top and bottom when sliding.

- the back fly wire door is not secure. It is unstable on its railing (falls off easily) - The external handle of the front door has fallen off - materials to be sourced by the Airtasker please

The bottom edge/panel of the garage door has been pushed in and also dented. The motor/remote works fine. The door still opens and closes smoothly and it's a single garage door as in photo. It just need to get pushed out/bented back. Thank you

I have a store room door that cannot be closed, likely a hinge issue from sea water rust.

Buy the door mechanism from bunnings. Install hardware to bathroom door. Repair damaged door. It has to be done on the 24th March before new guests check in.