Find experienced local carpenters in South Brisbane

Install a bathroom cabinet with secure shelving brackets into my bathroom. The cabinet has glass shelves and frosted glass windows. It will need to be reinforced in secure brackets. The wall for installation will require a stud finder to ensure the foundations behind the wall are secure where the install will be going

Remove 2 x damaged, broken existing hinges from cabinet Fit new matching hinges, align and adjust cabinet doors for smooth, even closing and proper gap alignment

* Install 2 mirrored shaving cabinets (wall-mounted) * Requires drilling through tiled bathroom walls * Cabinets need to be securely fixed and level * Experience working with tiled walls is essential to avoid cracking tiles * Please bring your own tools and fixings (or let me know if any specific hardware is required)

Require timber match to create nose on top stair tread. Timber is Victorian Ash with Integrain Silver Fir stain. Nose will need to be at least 7mm to allow stair runner to be screwed in/attached.

Repair one step tread, threshold, and window sill.

Repair where some water has got on the joins where the lacquer has worn away. polyurethane varnish or Cabot’s benchtop clear all areas. 2 benchtops and 1 island benchtop. All together a surface area of 2.7 squared meters.

Hardwood retainer wall construction , only 2 sleepers at the lowest point , and around a half sleeper at the highest point See pictures - a licensed builder has anchored the low end to the masonary steps and fixed a mitre joining on the 90 degree bend , builder has said someone just needs to continue the sleepers from there. Any questions please ask , all sleepers supplied tradesman just needs a powerful saw and batton screws.

I am fixing a small deck/step. I don't own a circular saw. I need someone to cut and install 2 x wood to support wooden boards ( I am attaching the wooden boards to the frame) and cut plastic drainage channel to fit two corner pieces. I am installing the drainage channel myself.

install: • 3 full-width shelves. • 1 vertical support panel to create 2 equal sections below. • The top storage area must remain completely open • Cabinet width: approximately 2250mm. • Cabinet depth: approximately 460mm. • Lower shelves divided into 2 equal bays • White melamine board preferred. • Shelves must be adequately supported to prevent sagging under normal storage loads. Also, on the top of the side of garage wall, install 5 meters panel in one side and 2+2 meters panel on the other side (install same as shown in the photo)

Clean patio, and apply timber stain. Approx 6x4 metres

Supply and Install 3 x overhead cupboards, flat pack from Bunnings

Needing a bedroom door replaced, I have hinges and door handle just needing someone to get a door and install everything for me

I purchased this from Bunnings: https://www.bunnings.com.au/specrite-2700-x-600-x-21mm-oak-timber-acoustic-panel_p0455959 I would like it to be cut and installed on the edge of my fridge cabinet, which measures approximately 600mm wide and 2100mm high. I'm looking for a clean cut, so it looks as close to built-in as possible. The tasker must use appropriate method and tools for this material (e.g. cut from slat side, tape to prevent tear-out, fine-tooth blade). They must also have the ability to tidy and reinforce the cut edge (glue/re-secure slats if needed). Hoping to have it installed using adhesive (no visible screws) with the panel to sit flush with cabinet face. I can provide the instructions if need be and I'm happy to pay for quality. Cheers, Alex

Measure and purchase timber rail and white brackets for stairs and install (will pay for items purchased)

need a custom rear cargo platform built for my van, similar to the attached photo. The platform should be flat and raised, with side panels to prevent items from sliding off. It will be used to store and transport surveying equipment, so it needs to be strong and stable. The structure should fit the rear cargo area of the vehicle and allow space underneath for additional storage if possible. Timber material is preferred. The surface does not need to be smooth or finished — durability is more important than appearance.

2 walls closed up Framed up , Gybrock walls ready to paint( owner will paint) Start tomorrow Friday 9am At coorparoo warehouse Timber and material supply by owner. See photos **

Kitchen drawers need to be made to fit this space. 4x drawers required. Have tried to source with various suppliers but the drawers are so old that a whole new set to fit the space needs to be built. Do not have measurements. Will need a measurement done and then drawers built and then return to site to install drawers, unless it can be done onsite.

I have 3 Kaboodle (Bunnings) Kitchen Cabinetry needing installation and also 5 tall lockers. These are in flat packs. All installation to be done within the same day.

Need to replace a door that has water damage. The bottom bit connected to the deck also needs to be repaired as I don't know what bits have rotted. The door needs a ledge on top (or an alternate fix) to stop rain water from being collected at the foot of the door. Will pay for materials ( such as door) seperatedly. Thanks

I am looking for a qualified Carpenter and/or Plasterer to repair damage in a downstairs rumpus room caused by a previous leak. The leak has been addressed and rotten wood removed, but I now need the following remediation work: • Carpentry: replace/reinforce timber framing in the corner where wood rot has occurred. This includes the area around the window lintel/header and the ceiling joist corner. • Window/Door Frame: Repair or replace the timber reveals/frames that were removed during the investigation. • Plastering: Replace the missing section of the ceiling (plasterboard), install new cornice to match existing, and patch/set the wall areas. • Finishing: Sanding and repainting. • I am currently seeking to understand the scope and cost of the work. This $50 task is for the site visit and formal quote. 2. Once the quote is agreed upon, I will increase the task price to the full quoted amount to cover labor and materials. Thank you