Find a local console repairer in Gold Coast

The primary task is to have our wooden countertops refurbished by having them sanded and recoated. We would like purchase the materials needed ourselves (we'll need a list from you). I've priced the job at $1200 as a placeholder and am open to paying more. The amount is not fixed. Airtasker only allows me to upload 5 photos; in the attached ones, you'll find the measurements and some photos of the countertops; however, to get a better understanding of what the work entails, I have uploaded a bunch more photos along with a video which can be found here: https://photos.app.goo.gl/Yo9NaNDCTuHD7dXY8 The primary job is to refurbish the countertops so please give us a separate quote for that. **Splashback**: Ideally, we want someone who can also replace the current tiled splashback with a polymer based splashback (pictured); however, we are open to a tiled approach if you don't have the experience with the polymer. Bunnings says it's as easy to install as tile is. As seen in the photos, you can tell that the back of the kitchen sink pools water and that has caused the most damage to the unit. On that section, we would like to add a thin layer of tilted tiles/polymer so that when the water splashes there, it goes right back into the sink instead of pooling. The section is rotted a bit but it's not too bad and we've been told it can be restored by a couple of builders who are doing other work for us. Note: The current sink and range will remain; however, we will be hiring a plumber who will be removing the sink to make way to remove the current tap and tap knobs that are fixed to the wall itself and replacing them with a tap that's like the one pictured which will be fixed to the sink itself. The plumber will do this work one day before you come. Ideally we want all the work to be done within one week to minimise kitchen disruptions as the home is occupied. Thank you for your time. Please give a separate price for the splashback installation.

Two shower heads to install..one with a rail. One set of taps to install.

Remove taps from bathtub & shower for bathroom demo

Wooden Merbu benchtops to be installed in new kitchen. Will need to recess an edge at the kitchen sink as this flows into the window as a ledge. 33mm bench thickness Benchtops are from Bunnings and are 900 wide 2400 long. 2 areas will need to be cut back to 600/650 wide (one of these areas is the recessed area which will be a bit wider to fit into the window sill. 1 area will be the full width to become a breaky bench.

These are 2 jobs that need doing to finish off the floor. Front door gap & back door & gaps anywhere else in flooring Also wardrobe, still needs shelving above the sliding draws. Just add 3 I left the big sheet for you to finish that off. Potentially 2 shelves in laundry Lastly I need you to hang the tv Brackets. Big one in living room, & small in bedroom

I need a set of side steps installed on my Holden Captiva 7. I have everything. Bolt holes only at rear door of car. Can’t see any in middle or front of car. So possible need 4 holes put in. I have the bolts already.

Through the house there are some paint chips that need fixing. 2 doors needs need a touch up where cats have scratched them, and a small section of a skirting board needs touching up. Please see photos attached

Few skirting panels to be screwed off, TV brackets installed Bench tops screwed off and door stop installed. Need to have tools including angle grinder.

I have a shower tap set and basin tap that need a washer change. However they are a square tap which I understand needs a special washer change. You would need to source materials as I’m unsure what to buy.

2x golden cane 2x agave and 1x yucca stump to be ground down if possible 🙏 thank you all for your offers in advance. Located in Southport to be done on Thursday if possible. Photos attached(the one still standing will be cut down before Thursday)

I need 3 stumps removed from My home would like a quote then job completion

Install 2x Water Filters and 3 Way Taps

We have 15 small tree stumps that we need someone with a proper chainsaw to saw near the ground. They are not big, mainly hedge or frangipani. We have cut down as best we can, just don’t have a chainsaw big enough to do it ourselves.

Fix up poor plastering workmanship. Patches around lights and a wall. Then repaint. Paint on site. General paint touchups.

Replace light bulbs and shower taps door handles, I have the door handles just not the tap handles

I need to jumpstart my car thanks

For licensed plumber- I need all tapware and fittings replaced in main bathroom and ensuite. This consists of 2 showers (shower head and wall taps), one bath tap set, 1 vanity mixer and one vanity basin set. Additionally I need dishwasher disconnected. Quick turnaround needed as property is going on the market Tapware all purchased.

Since the storm, all power is working but not the lights… it is the light switch on the circuit breaker that keeps tripping. It will stay on for about 4 secs then trips. Wanting to someone to come and find out what’s going on.

Shower head leaking, have two new tap fitting to be fitted.

with the task tomorrow morning if that suits you - View all the details of this offer: https://www.airtasker.com/offers/01JKF7RVZ7NEMPJFFEHPQHMBW9