Find skilled builders in Melbourne Western Suburbs

I had a pergola put up but it drips water through and the whole area underneath gets wet. I used silicone to stop the water coming through where the pergola meets the house but the water is coming through somewhere else.

I need someone to buy and install transparent roller shutters on my outdoor pergola

I need Shed assembled in the backyard on concrete. I have the shed. Measurements are shown in the picture and the picture of the shed is attached. Must bring own tools. 2.26 x 1.52

Install 6 × 3 m EasyShed and replace side gate Looking for an experienced installer in Burnside Heights to: • Assemble and securely anchor a 6 m × 3 m EasyShed onto an existing concrete slab. Shed kit supplied by me; concrete is already completed. • Remove the existing wooden side gate and supply and install a Colorbond gate to suit an opening approximately 1.9 m wide. Please source the gate and all necessary posts, hinges, latch and fittings. The gate needs to open across the full passage width so we can move carts and trolleys through easily. Happy to consider a double-opening gate. Please provide an itemised quote for shed installation and gate supply/installation, including removal of the old gate and rubbish. Final measurements to be checked before purchasing the gate. Photos attached. Please include your availability and examples of similar jobs.

Easy shed install of 3m x 3m x 2.4m as well as the concrete slab for it.

The pergola in Hoppers Crossing is about 8 m². I would like to replace one column post (bolted, no digging is needed) and a couple of rotted rafters, and then install new Suntuf Trimdeck roofing sheets. The frame, beams and footing are otherwise fine, so this is a like-for-like replacement with no structural changes. Please remove the old sheets, post and rafters. Please quote for labour only; I will pay for the materials from Bunnings. Photos attached. https://www.bunnings.com.au/suntuf-trimdeck-2-4m-clear-polycarbonate-roofing_p1010585 https://www.bunnings.com.au/100-x-100mm-2-4m-post-h4-treated-pine-sawn-cca-2-4m_p0051257 Please contact me by message, SMS or emails, not available for calls today.

Looking for an experienced shed installer to assemble and install a Colorbond gable roof shed (6m L × 3.15m W × 2.6m H). Concrete slab will already be completed. Installation to include full assembly, roof, doors and securing shed to slab in accordance with engineering plans. Located in Melbourne’s western suburbs. Please provide a quote and confirm your experience with similar shed installations.

I’m looking for an experienced tradesperson to inspect and fix an automatic louvre pergola in my patio area. The pergola is currently standing, but it seems to move in the wind and doesn’t feel stable. I need someone to fix this and install the pergola properly. If this can be fixed today that would be great. Budget is $500 and I am open to reasonable offers.

I need shade cloth installed under a pergola.

Hi i need someone to build pergola and extend decking at our house in Truganina cover sides over fence and install sliding door on 2 sides. Done my best to measure maybe little out Alfresco 3.078M 2.1 second side Height 2.1 Extension 2.9 length

Assembly of shed on concrete in backyard. I’ve already completed the back panel, it’s already been started.

I have a flat pack 4x8 shed that I need built onto a paved yard. The paving is quite thin but will still need a drill!

Install 3m x 3m easyshed

Repaint Outdoor Timber Pergola – Maribyrnong Looking for an experienced painter to repaint my recently built 8m x 5m outdoor timber pergola in Maribyrnong. The pergola has recently been painted green, however I’ve decided to change the colour to a warm off-white/cream. The job will include: * Preparation/light sanding of the existing painted surface as required * 1 coat of suitable primer/undercoat * 2 coats of exterior topcoat * Painting all posts, beams and roof rafters * Careful painting around the newly installed polycarbonate roofing and surrounding areas * Clean and tidy finish The pergola is new and the existing paint is also very recent, so the timber is in good condition. I’m happy to supply the primer and paint, or please specify in your offer if you would prefer to supply materials. Please include in your offer: * Total labour cost for the completed job * Estimated time required * Whether equipment/materials are included * Your painting experience/relevant reviews Photos attached showing the pergola and current green colour.

Dig holes for Pergola Post - 3 Hole x 2 Feet each . Ineed to install the posts, have the cement and everything. Bring your own tool to make holes

I want to build the pergola on 2 places in my house I’m happy to help to build it . But I need some one who has an idea of how and where we can buy all the items . I’m good with wood and have a knowledge about pergola but need some advice and hands to help build it. Regarding the price we can talk about it.

Looking for someone to demolish a small bathroom (approx. 1.6m × 2m) and small laundry. Scope: * Remove bathroom floor tiles, vanity, shower, bath and toilet * Remove laundry floor tiles (no wall tiles) * Remove sliding wardrobe and floor tiles underneath * Remove and dispose of all demolition waste Small job – please quote. Experience preferred.

Hello, I'd like to get a basic gate installed between existing fences that have a spacing for a single car driveway. I do not have existing materials. The spacing is 2.8 metres. Maybe around 1.5 metres for the height, but I'm flexible and it definitely doesn't need to be as tall as the fence. Will need the fence for basic privacy and security purposes. It needs to be porous to wind as a previous gate failed under wind stress. The system should be able to accommodate a basic lock setup (e.g chain/latch and padlock) but I can set this up myself so it does not have to be included in this job. Open to second hand components if they do not compromise the durability of the construction and it reduces the overall cost. The existing adjacent fence posts may need reinforcement after the gate is added. A photo has been attached. It shows a former gate that is no longer there. I do not require the same design as this former gate.

Assembly of an easyshed Narrow Slider Shed Currently in the box Easy access Final shed dimensions 2.25m wide x 0.78 deep x 1.80/1.98m narrow Please only bid if you have assembled one before Assembly instructions are online here