Find skilled builders in Clyde North

Hi. I am after installation of a louvred pergola attached to the house by a ledger and 2 detached posts. The pergola measures 3m x 4m. I haven't yet bought one so if you have any recommendations, I would greatly appreciated. Also, I would like flashing at top of the ledger to water proof. Thanks.

Would like to get done the coloured concrete driveway front of the house. Please see the plan. Also normal concrete 0.8 or 0.9 wide around the house. Very flat land.

I’m looking for an experienced concreter/driveway contractor to extend the existing driveway area at the front of my house. As shown in the photos, I would like to utilise the grass area beside the existing driveway/footpath and extend the driveway approximately: Length: 5 metres Width: 2.5 metres Total area: ~12.5 m² The new section should seamlessly connect with the existing driveway and be suitable for vehicle parking. Scope of work: Remove/excavate existing grass and soil Prepare and compact the ground/sub-base Supply and install appropriate reinforcement/formwork Pour and finish concrete to match the existing driveway as closely as possible Ensure appropriate levels/fall for water drainage Clean up and remove all excess material/rubbish Ideally match the existing exposed aggregate/finish (please advise what would be suitable based on the existing driveway) 📍 Location: Clyde North, VIC

Need somebody to assemble a new shed. 3x2.25 Skilion Roof Shed from Easy Shed. Located Clyde North

Need an extra pole/ panel for a pergola. In monument colour

Looking for an experienced carpenter/pergola installer to build or supply & install a decorative arbor pergola at the front façade, similar to the attached photo. Approx. 1.5m × 5m 2 sides have solid brick walls for secure fixing Only 1 strong support post required on the open side 2 PVC sheets on top – approx. $60 each, reasily available Can build from scratch or source a suitable ready-made structure Neat, strong finish required Please quote labour and metarial including. Experienced trades only.

In need of someone to relocate an existing shed I have in my backyard (photo attached) to the same side of the wall few feet away and assemble a new shed I bought ( please see photo ) the existing shed I have is smaller than the new one.

I want a quote to get my driveway and any other areas( let me know what you offer) for a new build. Please quote for different types of stone used.

Need garden shed installed. 2.2m × 1.52m.

DRIVE WAY & PERIMETER CONCREATING

Hello, Please provide a quote for the demolition and removal of two drywall partitions, including clearing and disposing of all debris. Please also include preparation and painting of the affected areas after demolition, including all labour, materials, patching, sanding, and final clean-up. The two walls are small partition walls. I prefer the interested contractor come and have a look before the quote. Thank you Regards, Vignesh

I need my deck to be done It's 13sqm I need 6 light in there I want composite decking Supply and install

Hello I would like to build a Pergola and enclose the pergola and exisitng alfrescoin ckyde north area. Please quote for pergola supply and install - 3m wide x 2.6m height. Enclosed sliding door - 1 side - 3.3m wide and 2.6m height 2nd sliding door - 3m wide and 2.6m height. Other 2 sides fixed glass panels same measurements. I want 4 powder quoted aluminimum posted. For enclosing glass doors prefer double glazed ones.

Need garden shed installed. 2.2m × 1.52m. Need basic concrete base.

Installation of weatherproof 2 x 10am gpo and weatherproof 2x15amp gpo in pergola. There is an existing 10amp double gpo already installed in the alfresco adjoining the pergola

We are a Home Maintenance Business and have a client in Clyde we need to pressure wash the garage (6x6) and driveway and re seal due to some building works. Please dont quote this as a retail job, this is a opportunity for you to get some additional work due to growth. Photos and ref are required of previous works. Would like this done next Thursday and friday if possible. Garage will be clear.

Need installation of Easyshed Gable style. Concrete base already done so ready to go. 3m length, 1.51m width and 1.97m height.

I want to get Bunnings shed to be assembled - Absco shed 3metre by 3 m

Professional assembly of an Easy-Shed Gable roof, with concrete fixings. 2.25m wide x 4.5m long x 2.35m High with portal frame kit *Shed getting delivered onsite and foundation is prepared. Flat access. * Easy Shed assembly experience and references preferred.

Want to get EasyShed Gable slider shed installed. Walls are partially assembled. Small 2.25m * 2.25m