Find experienced auto electricians in Adelaide

need to install electric car chager phase 1 near electricity meter. car charger may be telstra one or any other advised

I need an experienced car audio installer for a high-quality "stealth" installation in my 2007 Citroën Berlingo, which is a branded business vehicle. Reliability and a professional, factory-look finish are top priorities. I will provide the main components: Head Unit: Kenwood KMM-X705 Front Speakers: Kenwood XR-1800P (7” Components) Amplifier: Kenwood X302-4 (4-Channel) Subwoofer: Kenwood KSC-PSW8 (Active Underseat) Your Task & Quality Requirements: Install all components listed above. Mounting: The amp and sub must be mounted on MDF boards, secured using existing factory bolts under the front seats (Note: seats lift for easy access). No new holes to be drilled in the car's floor. Stealth Install: Tweeters to be custom-mounted behind factory dash grilles. Woofers to be mounted in doors behind factory door card grilles. Door Treatment: Apply sound deadening to front door skins and use foam speaker rings to seal the woofers. Wiring: Use high-quality Oxygen-Free Copper (OFC) wiring only (no CCA). All wiring must be neat and secure. Tuning: Perform a basic system tune (set gains, crossovers, and Time Alignment on the head unit). You must provide all necessary installation materials: Fascia kit, wiring harnesses, and adapters. Quality 8-gauge OFC amp wiring kit & power distribution block. OFC speaker wire & RCA cables. Sound deadening material for two doors. MDF for mounting boards & speaker adapter rings. Please make an offer inclusive of all labour and the parts you will provide. In your offer, please confirm you can meet all the quality requirements listed above. Thank you!

Hi there! We’re looking for an auto electrician to finish off a small campervan wiring job. ✅ What’s already installed: Kings 1500W power inverter (DC to AC) already wired and working. 🔧 What we need done: Connect an extra powerpoint somewhere in the van there is a spot with wire ready to go. (I haven't bought powerpoint yet but can go get from bunnings if the one in photo is suitable or happy to take recommendatin on another one) Wire a battery capacity monitor (coulometer) – the sensor and wire are ready, just need it connected to the battery and display panel Everything is easily accessible inside the van and parked at our place. Hopefully should be a quick job for someone experienced! 📍 Location: Marden 💰 Budget: $100 Please message if you’re available this week.

I need a front and rear dashcam installed please

install dashcam front and rear (Buying a new car and require a quote) 2025 Subaru Forester

Replace the headlight in my car. Need the parts too

Reverse camera installation on mazda 3 2008 hatchback. Connect it to apple car play.

I am looking for uninstallation of a front Dashcam from a 2008 Porsche Cayenne and installation of front and rear into a 2016 Audi SQ5. The Dashcam is to be hardwired. Link to the unit - https://www.viofo.com/products/a129-plus-duo-dual-channel-dash-cam-front-2k-1440p-rear-1080p-with-wi-fi-gps-dash-camera

I have GWM PHEV charger which needs an installation at home

Installation of a head unit and reverse camera on a Ford Ecosport. The head unit & Reverse camera unit is provided. For reference head unit picture attached . Please share your quote for installation of both.

https://www.supercheapauto.com.au/p/nanocam--nanocam-connect-wireless-smart-monitor-1080p-dash-reverse-cam-kit-nc-722dvr/658815.html#q=Nano&lang=en_AU&start=1 Needed to fit this in my car mazda 2 neo Quote for it please

Having electrical issues with my 2012 Suzuki swift. The car randomly stalls and turns off, goes into a limp like mode type state sometimes until it reaches a certain amount of revs

Plug at rear of Amarok needs to be changed from 7 pin to 12 pin as we have bought a caravan that had the 12 pin connection. Caravan has also come with a reverse camera that runs via wiring through the car to a detachable screen that sits over the cars reversing mirror. Must be a licenced Auto Electrician.

My car is not locking. Need to fix central locking system. Model mazda 6 2004

ve commodore misfire cylinder 3

Van not starting - computer code/description "Intake manifold flap change over valve open circuit/short circuit to ground"

After someone to install carbon looking plastic front lip, side lip, rear small spoiler and rear diffuser. Side mirror capping. Happy to do front lip at first. On a tight budget. Parts from very reputable Melbourne company. They can do it for a great price but I have to drive over there. Will attach photos.

Check the wiring of a camper trailer and secure new battery in battery box. 12v system with water pump, solar panels and some outlets