Find a local Nordictrack assembler near you

NordicTrack C990 (2020 model) won't power on. Console is dark, but the motherboard LED is lit, confirming power to the base. Scope of Work: • Diagnose why the console isn't receiving/displaying power. • Repair or replace necessary parts (Wire harness, Controller, or Console). • Budget: $400 total (covers call-out, labor, and any required parts). Location: Vermont, VIC 3133.

unpack and assemble the treadmill, I am happy to help (extra hand) if after 6 pm this week

Nordictrack exercise bike resistance repair needed. Possibly resistance cable requires realignment . Motor seems to be ok but may require replacement.

, I have a NordicTrack X32i treadmill in Wheelers Hill that cuts out completely at a particular higher speed — screen goes dark and belt stops, only restarts after ~30–60 s. It’s plugged straight into the wall. I’d like a technician experienced with electrical/control board diagnosis and repair. Please provide your call-out fee and availability.

Nordictrack commercial 2950 not declining otherwise working well

Uninstall Treadmill Relocate Treadmill to Rasmussen Install treadmill No Stairs

Suspect cable fault or short.

I need to move a NordicTrack treadmill from our garage to a bedroom. The treadmill is too wide to relocate and requires removing the running track from the rest of the treadmill (i.e., upright bars, side bars, and a screen). I understand the treadmill can be disassembled into two parts (the running track and the rest) to fit through our hallway. Quote needed to (1) dismantle in the garage, (2) relocate to the bedroom, and (3)reassemble there?.

Nordictrack treadmill. Needs to be reassembled. Arms, console and screen. Deck still intact. Some tools may be needed. Heavy treadmill. Will probably take 1-2 hours. Available weekends or after 6pm Monday to Friday

My NordicTrack treadmill mechanism isn’t unlocking to lower today as it always does. Also, I would like to add lubrication in the necessary areas of the machine to minimise friction, safeguard the motor, and prolong the lifespan of the deck and belt. I have not applied any lubrication since the purchase.

Hi! I’m looking for an experienced treadmill technician to help with my NordicTrack T8.5S. It has a few issues that need attention: What needs doing: • Reset/console screen isn’t working properly – need someone who can diagnose and fix the reset/boot-up issue. • Full service to get the treadmill running smoothly. • Incline squeaks when adjusting – likely needs lubrication or adjustment. • Belt clean + alignment check to ensure safe, smooth use. What I’m looking for: • Someone experienced with NordicTrack or similar high-end treadmills. • Ability to troubleshoot console/screen issues. • Must bring required tools. Location: Newport, Melbourne Timing: Flexible — ideally sometime this week or next. Budget: $120–$150 depending on experience and diagnostic requirements. Please comment with your experience and availability. Thanks!

Full assembly required, still in box.

I have a Nordictrack treadmill that needs repair. I did have James from Airtasker come out months ago and he said he was going to order the new part but he has since gone quiet and won’t return my messages. I have a picture of the part he pulled out of my treadmill.

Nordictrack treadmill not powering up need to be checked and fix along with its service

Looking for someone experienced with treadmill repairs to diagnose and fix my Nordictrack C1650 treadmill. It’s not turning on.

Treadmill was previously working until I disasembled the console to move it through a doorway. Potentially some wires have either been disconnected or the wire next to the ground wire needs a DIY wire repair from a technician or someone with electrical knowledge. It currently turns on OK it's just that the buttons are not responsive. Even the heart rate monitor is running fine.

I need someone to dismantle my treadmill so it can fit through the door to be moved to another room. It’s too wide to roll through the house. It needs to be rebuilt in other room too. Electrical’s have to be disconnected first to take the base off so please someone who has done this before.

The treadmill requires a control board to be replaced, i have the new control board ready to go

Reassembling a Nordic track treadmill. Was part disassembled so it could be moved. Will need own tools.

Treadmill won’t function