Book a trusted oven repair and installation expert in Greensborough

Install a hard-wired oven, new oven is a single oven, existing oven is a double oven. Cavity will need a shelf installed for the single oven to sit on and the bottom borded in.

Omega ofgg7gvxa freestanding gas oven turning off after approx 30 minutes. Starts fine.

UNOX combi oven. Works well just doesn't reach to high temperature. New seal installed. But temperature doesn't reach over 150 degrees Celsius. Need someone to come either 7:30am or after 5pm as kitchen is very small.

Westinghouse double oven PDL 790W, the top oven does not heat up. Lights go on, but no heat. I haven't checked the lower oven. Also, the top oven door doesn't open all they way, so that could be fixed as well.

the oven now will not stay lit. When trying to light the oven, I would turn on the gas and then pull the switch to ignore the flame. I would hold it for around ten to fifteen seconds and then let go which would keep the flame burning. Now (as of uesterday), when lighting the gals and pulling the level in the over to ignore the flame, it will ignite but the flame goes out as the gas stops as soon as it is let go. I have done research with the help of Andrea which Made a few suggestions. As I did not wish to try and take the oven apart to do anything, I did notice that it said that I could hold it longer and that would help the element heat up. I did this for nearly a minute and it stopped straight away as soon as I let the lever go. I also decided to leave it over night just incase it needed some time and today it is acting the same. We use the oven multiple times a week and it would be great if this could be looked into. I am hoping it is only something small. One investigation said that it could be a small metal item that is near the inner pilot that is not registering the the flame has heated up and thus turning the gas off for safety reasons.

Bosch Mircrowave has stopped heating and switches off.

My inalto oven has stopped working, it turns on but does not heat up.

Supply and install 2 x 16A dedicated oven circuits, including safety switch protection and appliance fit off. Supply and install Clipsal Classic double power point for fridge, existing point is currently sitting half behind the cabinetry. Supply and install Clipsal Classic double power point for dishwasher, redirect existing cable allowing space for the new appliance to fit. Install additional power point above kitchen bench - socket present - Due date: Before Friday, 3 November 2023

microwave oven blows fuse in oven - Due date: Flexible

I have an old chef free standing stove oven and I bought a new one. Need a licensed plumber to disconnect the old one and install the new one. And dispose of the old one. - Due date: Before Friday, 2 June 2023

Porter and Charles 900mm electric under bench oven is not heating up. Fan is working fine, just not heating. Last used Friday evening and it was fine. - Due date: Needs to be done on Monday, 26 September 2022

Hi there I went to oven the door to put something in the oven the noise came from the back and it was the fan. The fan of the oven doesn’t work and not heat coming out.

Need seals on ARC oven replaced, clean out of residue from blown filament, and replacement of filament. ASAP would be good, as need oven! - Due date: Flexible