Book a trusted oven repair and installation expert in North Brisbane

Job: Fit a suitable power plug/connection to a newly purchased integrated oven. We have just collected a new ASKO OCM8487A 45cm compact combi oven. It has arrived with the power cable/wires exposed as shown in the photo, and we need a licensed electrician to fit the appropriate plug/connection so it can be safely connected to a standard power outlet

I need an experienced cabinetmaker to modify an existing kitchen appliance cavity to accommodate an ASKO OCM8487A 45cm compact combi-microwave oven. The oven is currently a few millimetres too large for the existing cavity, so I need the cabinetry professionally modified to achieve the correct manufacturer-required dimensions and a clean, built-in finish. Scope: Assess existing cavity and oven dimensions. Determine the best solution (e.g. carefully widening/adjusting the cavity or modifying internal cabinetry). Modify cabinetry as required. Ensure the oven is correctly supported, aligned and has the required ventilation/clearances. Finish neatly to match the existing kitchen. Oven is already purchased and available on site. Photos of the existing cavity attached with an au generated photo with the purchased oven showing what we are wanting the end outcome to be. Looking for: Experienced kitchen cabinetmaker familiar with integrated ovens. Ideally someone who can inspect, recommend the best solution and complete the modification in one job.

The oven stops and then restarts at the minimum temperature.

I need an oven installed. It requires electrical wiring and pack out the extra space. It is going from a 70cm oven to a 60cm oven in the same cavity.

I need an electrician to assist with disconnection and replacement of (I believe) separate hardwired oven and cooktop. Oven is Westinghouse WVE6516SD and cooktop Devanti CCT-B-4B-4Z. Based on my research, both should fit with the existing enclosures and I can do any work needed if they don't, just need the electrical done and the testing and compliance cert. Just trying to keep the costs down as much as possible in doing any cabinetry needed, and open to two callouts (1 for remove and 1 for instal) if that makes it easier.

Please quote to convert zio ciro subitto cotto 60 pizza oven to natural gas from lpg We have the conversion kit (pictured), i understand a length of hose is still needed to connect to the natural gas outlet (variable lengths so wasn’t included).

I have a new oven and induction cooktop to be installed. The old appliances have been removed so just new an Electrcian to connect the existing wiring to the new appliances. I work from home so can very flexible if you want to do this between other small jobs or if you are passing through the Nundah area to or from other jobs. I can send more pictures of the electrical drawings in case you will need additional supplies to complete the job. If you have questions, please reach out.

Need someone experienced to remove the existing 60cm built-in oven and install a new IKEA KULINARISK 700 oven (also 60cm). Please fit securely, connect to existing power, and test once installed. Photos attached. Please provide your current electrical contractor licence number and proof of public liability insurance with your offer.

Oven trips mains when selecting cooking mode on dial Oven ights come on, any other selection causes trip 90cm Electric Multifunction Oven EO900MX2

The ‘press on’ sensor button is not registering. I think the casing that supports the spring is broken.

Licensed Gas Fitter Needed: Disconnect Old Stove, Modify Pipework & Connect New 90cm Range Cooker Description of work: Looking for a fully licensed and insured Gas Fitter to swap out a freestanding kitchen stove in Fitzgibbon. The Job Involves: 1. Disconnecting and safely removing the old 90cm gas stove. 2. Modifying the existing floor-mounted copper gas line. The current regulator and yellow isolation valve sit too high up off the floor boards and will obstruct the new oven. Need the pipework cut and altered so the connections sit ultra-low/flush to the wall, allowing the new oven to slide completely back into the cabinet cavity. 3. Connecting the new 90cm dual-fuel cooker (cooktop is gas, ovens are electric) using an approved flexible hose. 4. Testing the system for leaks and issuing a QLD Gas Compliance Certificate. Photos of the current floor-mounted gas connection, and photo of the proposed new gas stove are attached. Flexible on timing to align with delivery. Please state your gas license number when making an offer.

remove and unplug existing freestanding oven. And wire and plug new one

Need quote for labour to connect new freestanding oven to mains. Chef 540mm Freestanding Electric Cooker with Conventional Oven - White

Looking for a licensed electrician to disconnect and remove an existing hardwired combination oven/cooktop unit, and assess the existing wiring to advise on what’s needed to install a separate built-in oven and cooktop as replacements. Need to know whether the existing circuit and cable can be reused, whether a second circuit is needed for the oven and whether the switchboard has capacity.

Our tenants have advised that the Westinghouse gas oven is only working when the temperature is turned up to the max and that even still it doesn’t seem hot enough, they can see the flame but thinks the heat is leaking somewhere.

Technika oven not working due to power tripping off

My oven is not working properly. I think the grill still works and the fan and light, but otherwise the oven is not heating at all. Needs to be fixed asap, preferably on Tuesday.

Needing to install a Smeg electric oven into an existing cavity with oven that’s already been hardwired. Need a licensed electrician.

Fan oven is not heating, grill is working

Need oven reset, control panel not working. Oven can’t turn on. ilke oven.