Hire a trusted appliance repair service in Blacktown

Ixl eco tastic light fan heater not turning on

Haier refrigerator giving E0 error May be a faulty temperature sensor needs to be replaced

Need someone to fix my washing machine. It’s leaking water, but the leak is NOT coming from the hose connections. Looking for someone experienced with washing machine repairs who can diagnose and fix the issue. Please message with: - Your experience - Availability - Estimated call-out/fix cost Located in Dean Park

Im a small restaurant, my coffee machine was not heating up and there were no pressure from hot water wand and milk wand. I need asap service

Dishwasher is making noise when turned on. Its not completing a cycle and showing error on screen

The belt of the treadmill needs to be repaired

One of my burner on the gas top, it’s not turn on it. Just turns off when I try to turn on. please check the video.

F12 Error after few minutes. Stops after that with the beep

Fridge is not cooling, blowing air but not cold both fridge & freezer

Rubber smell and smoke coming out from the drum, on my asko washing machine. Need someone to fix it so we can use it again.

Fix the wall socket which is behind washing machine and also fix the legs of washing machine all tighten the screw basically

OSIM UDivine V massage chair It looks like no power. No response. Checked and tried to switch to another the power point. Switch was On.

I have a pouch filling and sealing machine that has a bottom heating element that is not heating up

Display fridge may have a small leak. We had the gas filled on 24 Apr and it's again running at 26 degree today. Need to check and fix the leak if any and fill the gas.

Budget not accurate, please quote accordingly. I need someone to fix my donut fryer. The gas pressure is way too low and needs to be adjusted.. there’s 2 dials but I don’t have the equipment to do it. I have 3 of these machines from the same supplier and all the other ones work perfectly. The supplier said it needs to be adjusted but won’t tell me how unfortunately.

I think it's the balancer underneath the tub... It's loose and wobbly...

Hi, I need help repairing a Creaform C-Track 780 controller used for an industrial 3D scanning system. The issue: - Controller receives stable 24V power - When the power button is pressed, it powers on for around 2 seconds - Then it shuts off - After that, pressing the power button again does nothing unless the power is physically unplugged and reconnected - PSU has been tested and appears to output 24V - The issue seems to be inside the controller, likely a power regulation/protection circuit issue Likely fault could be: - DC-DC regulator failure - Capacitor issue - MOSFET/protection circuit fault - Internal power rail fault I am looking for someone experienced with board-level electronics repair, especially industrial equipment, power supply circuits, DC-DC regulators, and SMD component diagnosis. Please only respond if you are comfortable diagnosing and repairing PCB-level faults, not just basic cable/adapter repairs. I can provide the controller, PSU, photos, and test results. Ideally looking for someone in Sydney or nearby, but can discuss shipping if needed. Please provide your experience with similar repairs and an estimated diagnosis/repair cost. Thanks.

Need electric reliner fixed

My washing machine no longer spins. Its a Kogan top loader washing machince

The drum of my battle made loud noise when I was dryer and now it doesn’t spin when the dryer is turned on