Find professional window and door services in South Brisbane

Needing 2 x doggy doors removed and patched and then rendered to match existing.

I’m looking for a quote for someone to come and cut a round hole to fit in a dog door.

Repair Window gap. Intially had air condition seating on the window Located in browns plains

I have a job on today where I need an offsider to hold one end of a roller shutter awning. We will be on ladders with planks going across. You don’t need to be able to use tools or anything, just be able to hold one end of the roller shutter whilst I fix it in place, There are 2 awnings to fit.

Pressure cleaning outdoors with no tap attachment only electric plug, closest water source is kitchen sink tap requires connector to attach to hose. Sliding door and window also to be pressure cleaned as well as balcony floors and walls, small table and 2 wicker chairs.

3 NEW FIRE DOOR FRAMES INSTALLED

The glass is cracked and also the doors were not sliding along the tracks properly

3 x garage door frame supply and install no painting required

I just replaced the old front door. I need to get rid of the old door and frame.

Install cat flap into door with fly screen.

It’s commercial glass door with a metal frame and hydraulic door closer at the top. Can’t open this door as it’s jammed and lining inwards. It’s heavy. the door is rubbing against the frame which is near the top right corner, it is slightly misaligned.

Door is sometimes stuck.on top right and dont close properly

Looking to reattach a cabinet drawer and door in our kitchen. We've got a cabinet drawer that has snapped off on one side, and a cabinet door that has come off, I'm guessing it needs hinges replaced? Also, keen to know if some laminate that had peeled off can be replaced? Photos attached

Measure, source and fit new bedroom wardrobe doors.

It’s very small job, I need someone to put door bell !!! Tomorrow just nail job ,

Hi, I need help swapping and rehanging two internal doors. 1. Remove the current door from [room → entry way] and replace it with a glass panel door 2. Install hardware (door handle, latch, striker plate) on the new glass panel door. 3. Reuse the original solid door and hang it on the doorway into the garage (currently no door hung there but there was previously). The door may be a few millimetres too wide for the garage frame, so it might need to be trimmed or sanded back slightly to fit. Ensure both doors are hung straight, open/close smoothly, and hardware is fitted properly. What I’ll provide: - Both doors - Door hardware (knobs, latch, striker, hinges) What you’ll need: - All the tools for the job

Hi, Our door was unsigned during a delivery. Noticed door not closing properly now as it is unaligned. Requiring door to be aligned so it can be fixed. Needing this done asap as this is a safety concern. Thank you.

Must have experience or knowledge of repairing these doors.

New carpet has been installed in a bedroom and now the internal bedroom door cannot close easily. Need a few mm shaved off the bottom of the door.

I need a shower screen panel and bathroom installed