Find a professional garage door installer in VIC

Cable needs to be retied

One extension spring on my tilt garage door has fully detached — the spring, anchor bolt, washer and rubber bumper have come off at the top anchor point and the spring is sitting on the floor. The opposite side is intact and working, so there’s a reference to match against. Need someone experienced with garage door springs to: • Supply/match correct anchor hardware (part-thread hex bolt, mudguard washer, nyloc nut) etc • Refit and tension safely, door open/supported • Check the working side too, since springs are a matched-age pair Appears as though the bolt has bent and come loose, spring and frame appear to have no damage. Just needs to be reattached

One of the centre hinges on my ECO sectional garage door has broken and needs to be replaced. * The garage door spring is not broken. * Only the centre plastic/composite hinge assembly has failed. * The door is currently closed and the opener is disconnected. * I have photos showing the broken hinge and the door. * I would prefer someone experienced with sectional garage doors to supply the correct replacement hinge and install it. If you are unable to supply the part, please let me know which hinge is required and I can source it.

Hi everyone, I'm looking for someone who can repair a sectional garage door. One of the door panels has been damaged — the bottom rail and the outer metal skin are noticeably bent. I'd like to explore two options: Panel beating / straightening it back — is it possible to reshape the bent metal so the damage is barely visible afterwards? How good would the finish realistically look? Replacing just the damaged panel instead of the whole door. I'd appreciate your honest advice on which option makes more sense, and roughly what each would cost. If you're a garage door technician or can recommend someone reliable, please let me know. I'm also looking for a free quote. Tha

I have just reversed into my garage door as it was still going up and hit the bottom. It is the the bottom panel/rail that need to be put back into shape - everything is still full functional and opening and closing etc.

The door from the garage to the backyard does not shut. Maybe it needs to be sanded down, looks like due to swelling.

Remove old garage door opener and replace with new unit. Current unit is faulty and needs replaced NOT serviced. Single garage roller door Need basic opener with At least 2 remotes

I want to repair a dent on a garage door it was a dent by car so just need to be fixed so it can be plain

Need a lock and key installed for my garage door

We have a Steel Line automatic garage/roller door that has become stuck in programming mode after pressing buttons on the control unit to try get it to stop beeping for a service it got stuck in program mode. The system is now flashing a “4” and the door will not operate correctly. The motor is not broken as were were able to get to go up and down with the + and - but can’t get it out of program mode. It’s making noise but the door is not completing any movement cycles and appears to be stuck in setup/learn mode. We have already tried basic resets including power cycling, but the issue has not resolved. What we need: * Someone experienced with garage/roller door motors (preferably Steel Line systems) * Reset/exit programming mode * Recalibrate or reprogram travel limits if required * Ensure door is fully operational again Details: * Door currently not functioning properly * Motor still powered and making noise Looking for someone who can attend as soon as possible and fix the issue. ⸻

roller door lost tension on left side pushing it down. ballooning when force opening

One of the hinges on the garage door appears to be broken. This needs to be replaced and the gaps between the frames need to be tightened.

Installation of secrional garage door motor only. 4 section garage, motor attached to ceiling. Please provide quote with and without the appliance(motor)

Frame of the garage door need to be finished, should include material and labour.. Look the at pic to assess. One in the ivory colour is the one that I want framing to look like.

The garage door gets stuck half way while closing, I think there is an issue with the hinge in the middle that guides it close.

Need garage door seal replaced See photo Please quote Must be done before tuesday

My steel line garage is going slow and it needs service or it might need need lubrication .

Install a garage door manual lock Lock from inside

Hi all, looking for someone who can fix the tension on my garage door. Won’t go up and won’t go down with the remote and garage button but can push up and pull down.

Clumsily hit the last panel on my garage door. Still opens and closes. No labeling on the door so not sure if this means a whole new roller or it can be fixed. Still opens and closes 2440 long 2880 wide Not sure what price to put in depending on wether its fixable or a new door is needed