Find a local garage conversionexpert in VIC

Quotation please …. Hybrid flooring I need an experienced flooring specialist to supply and install premium flooring in a 28m² garage conversion project in Melbourne. The garage (7m x 4m) is being converted into an office, storage and small living area. • Prepare and level the existing concrete slab subfloor as required • Install skirting boards to match the flooring finish • Neat and clean finish to all edges and transitions

Hi, I’m looking for someone experienced in building permits in Victoria to help obtain a permit for converting my garage into a studio. Scope: Preparation and submission of building permit application Required drawings/documentation (can coordinate if needed) Liaising with building surveyor/council

Garage 5.3m x 3.6m made of single brick with some double brick pillars requires an inner wall of wood frame and plasterboard. Also a ceiling is required, including new battens to be attached to beams (beams are spaced 0.8 m apart so too far apart for plaster to be attached without battens) Garage door to be replaced with a sliding door (I purchase this). Any gaps around this filled with wood or wall. Also needed is a 2.3 section of internal single-sided plaster wall separating garage from the adjacent shed/studio. Photos have wood airing against walls and boxes - these will be moved by me asap.

Half of Garage Conversion to 1-Bedroom Unit – Labour + Materials (~$45k Target) Looking for an experienced builder/team to convert an existing garage (~7.9m x 5.2m) into a self-contained 1-bedroom unit. Floor plan available. Scope of Works: Framing: Internal walls for bedroom (with robe), bathroom, European laundry, and open-plan kitchen/living. Linings: Insulation + plasterboard (moisture board in wet areas), set and sand ready for paint. Flooring: Hybrid flooring to living/bedroom, tiles to bathroom/laundry, skirting installed. Waterproofing & Tiling: Waterproof bathroom/laundry. Tile bathroom (floor + shower), laundry floor, kitchen splashback. Kitchen: Supply & install basic cabinetry, laminate benchtop, sink, oven, electric cooktop, rangehood. Bathroom: Supply & install shower (900x900), vanity, toilet, tapware, accessories. Laundry: Cabinet/storage, washing machine connections, tiled floor. Electrical: Lights, power points, exhaust fan, smoke alarm. Plumbing: Full rough-in and fit-off (kitchen, bathroom, laundry). Split System: Supply & install AC to living area. Painting: All internal walls, ceilings, trims, doors. Finishing: Site clean and rubbish removal. Notes: Existing structure only (no major structural changes) Budget/rental-grade finishes (not high-end) Builder to supply labour + standard materials Open to cost-saving/value-engineering suggestions Permits handled separately if required Budget Target: ~$45,000 total (labour + materials) Please include: Full quote breakdown Timeline Inclusions/exclusions Examples of similar work

I need to convert my garage to a temporary music/photo studio. All attachments need to be temporary since im in a rented house Budget 25$ph

I have garage that i want into barber shop i need someone to put black panels and paint walls black also fix the electrical situation with the hexagon lights, and make power point on right side of garage. Attached some floating shelves. Put in a aircon. And put a sliding door infront of garage door. And i want to out hair wash basin i know that needs a better quote in person but let me know. thanks

Roller door replacement, plastering, flooring required in the garage

Convert partial garage to living space 6 x 3 -frame up and plaster -insulate roof and walls -raise floor -install floor boards -Supply door and locks for main entrance and bathroom -install toilet and shower with basin -paint -organise plumbing (trench to be dug approx 6 meters for sewage -unblock drainage can (plumbing can be done in seperate quote) -electrical will be done by my as I’m a licensed electrician (Garage a bit messy atm but photo attached where I want the works done

Not sure how much this will cost so give me your best offer! Want it done properly but also as cheaply as possible.. see pics pretty standard garage would like to put in ceiling, floor, and new door to outside. Also lighting, and take paint off windows to let more light in.. and anything else you think should be done for a decent conversion/ home office/studio type job.

Convert garage into an ensuite bedroom

Need our double garage converted into three rooms. Rumpus, bedroom and study. Permits required. Plans being drawn up, initial drawings as shown.

Hi guys, I need a Victorian registered drafter to do a working drawings to convert my double garage into a bungalow (2 beds and 1 bath, 1 kitchen and living). My property is in Oakleigh South, Vic. The work requires building permit so works need to be complied. Also, you can supply energy rating reports and other engineering works (if surveyor requires). The working drawings is needed to obtain building permit. Please let me know the best quote and how long it takes to get works done. Thank you,

Hi guys, I need a drafter to do a working drawings to convert my double garage into a bungalow (2 beds and 1 bath, 1 kitchen and living). The work requires building permit so works need to be complied. Also, you can supply energy rating reports and other engineering works (if surveyor requires). The working drawings is needed to obtain building permit. Please let me know the best quote and how long it takes to get works done. Thank you,

New house has a carport that has been attempted to be converted to a garage. Require help to complete the job started by the previous owner. Requires innovative solution. Needs framing, cladding - so water tight. Water barrier at bottom of frame. Approx measurements: 6m long, 3m wide, 2m high. 3m already framed. Cement sheet cladding is fine. One 20cm fascia board needed at rear door Plastering not needed.

Extend and convert garage to granny flat

Need to sort out the roof of existing garage to convert into living space. Stud out small bathroom and plaster board ceiling and walls ready for plastering.

We want to convert an existing garage into living space and need to sort out existing wiring with new plugs and sockets before walls get finished.

HI, we want to convert our double garage into a Nails Salon. Please find below work done so far: 1. Approached a Draftsperson and have house drawings. 2. Approached a Building Surveyor and received a list of things to do. However, there are alot of things on this list which we do not understand which is why we now need a builder to help us through the project. You will need to have a builder license for this work. We have limited budget and hoping to engage a builder which is cost effective and helpful.

I am planning to convert my garage into a Small Office Unit (SOU) with a bedroom and bathroom, located in Saint Albans, Melbourne. I seek your expertise to ensure compliance with the National Construction Code (NCC) and to navigate the permit process efficiently. Below, I've outlined the specifics of my project with attention to compliance requirements: 1. **Insulation**: To meet the NCC's energy efficiency provisions, particularly Section J for residential buildings, I intend to incorporate high-performance insulation in walls and ceilings, ensuring an optimal thermal performance rating. 2. **Plumbing**: The addition of a bathroom necessitates compliance with NCC Volume Three - Plumbing Code of Australia (PCA), focusing on water efficiency, sanitary drainage, and waterproofing requirements. 3. **Waterproofing**: Adhering to AS 3740 - Waterproofing of domestic wet areas, to prevent moisture damage and ensure the integrity of bathroom areas. 4. **Ceiling Height**: In alignment with NCC Building Code of Australia Volume Two, Part 3.8.2, the conversion will feature ceiling heights of at least 2.4 meters for more than two-thirds of the floor area, providing adequate headroom and ventilation. 5. **Windows and Natural Light**: Upgrading garage windows to double-glazed units to enhance thermal efficiency and sound insulation, adhering to the NCC's Part 3.8.5 requirement for natural light. The design will ensure window sizes meet at least 10% of the floor area, aligning with NCC Volume Two, Part 3.8.4 for natural lighting. 6. **Garage Door**: Considering the installation of a new garage door with integrated windows, to fulfill the NCC's natural light requirements while contemplating aesthetics and functionality. The design will ensure compliance with relevant Australian Standards for garage doors in residential applications, considering security, insulation, and operational safety.

I am seeking an experienced and reliable window installer to replace two existing windows with new, double-glazed units in my property located in St Albans, Melbourne. The current window frames are set within a single brick wall, and the upgrade must meet all National Construction Code (NCC) requirements for energy efficiency, safety, and installation standards. Project Details: Location:St Albans, Melbourne, Victoria Scope: Window Replacement:Remove two existing single-glazed windows and replace them with high-quality double-glazed units. Compliance:The installation must adhere to the NCC's specifications for thermal performance, structural integrity, and waterproofing. - **Frame Consideration:** Current windows are set in a single brick wall, requiring careful removal and installation to prevent damage. PS: Budget for total project garage conversion project is $16,000.