Find experienced local fence contractors in California

My backyard gate is a struggle to open. A few of the wood boards need to be replaced and then the gate needs to be rehung to the adjacent block wall.

I have the all the material to get the job done just don’t have the time to do it. I need a chain link fence and 2 gates installed.

I have a property with three separate dwellings and want to partition them so that each unit has their own gate, preferably with a doorknob and key. I also have a gate on the other side of my fence that needs to be repaired so it can be opened and used. And I need to be able to pay with credit card (Amex).

just screw fence back into posts

Fence post is wobbly. Need to make it steady.

Large panel section fell during the rain and wind storm. Boards are broken .

Section of Backyard fence fell down need repair

My fence fell over with the windy weather. I need help lifting it and propping it up until I can afford to have it properly replaced or rebuilt. I think it will be in the $1000s to replace, and I just don't have that right now so I just need to temporarily reinforce it for now.

The wind blew out a few pieces of my vinyl fence. I can't weasel back behind the planter because I have a pinched nerve in my lower back but I would love to get some help fixing it so my neighbors can stop staring at the wood board we used to cover it for the moment. The vinyl pieces pop in easy enough but the hard part is wedging the last piece in. I have a crow bar and moral support but that's about all I'm good for right now lol.

Wood fence repair - Renail boards back to posts

One of the hinge of the gate came out. Needs to be reinstalled. Gate lock is also loose therefore, needs to be installed by drilling another hole. I also want 1 hole at another wall (from outside) to reroute the internet cable

I need my iron bar fences re-welded at the broken points. 4 points total.

I'll provide the wood and needed tools i just need the labor part in building it. It's about a 20 foot fence line .

need a motor & installation on an approximate 10’ long iron gate.

My mom's house is on the market. The fence in the backyard is in obvious need of replacement. A small section blew down in the recent wind. I'd like to have that section repaired.

My wooden fence posts is wobbly and the fence panels keeps falling over I just need the replaced and the panels placed back on

I need a quote for my fence

I’m looking for an experienced fence installer to correct and complete a Postmaster fence frame. Current Condition: • There are 4 Postmaster steel posts currently installed. • 3 of the installed posts are not straight or aligned and are off by approximately 2–3 inches, which is why they need to be removed and corrected. Phase 1 – Current Scope: • Remove 3 existing posts, then re-install those 3 correctly. • Install 2 additional new Postmaster posts, for a total of 6 posts installed. • All posts to be straight, plumb, level, and properly aligned. • Posts to be set 6’ on center, approximately 3’ deep (gravel base + concrete). • Posts are 10’ Postmaster steel posts and are already on site. • Frame the fence correctly so it is ready for a future horizontal wood install. Equipment: • If needed, I can rent a Bosch 35-lb electric jackhammer for post removal. Notes: • This phase is post removal, correction, and framing only. • All materials are already on site. • Clean layout, accuracy, and attention to detail matter. Future Phases (optional, if Phase 1 goes well and you’re interested): • Horizontal Cumaru fence board install • Gates, rails, and refinishing (separate scope) Location: Near Melrose & the 101 (Los Angeles)

Repair vents and fencing for back yard

I need 50ft of cyclone fencing stretched over older wood fencing and secured to wood posts with brackets in small yard.