Find a professional local car service in Austin

Task Title: Pull & Swap Rear Hatch - 2016 Chrysler Minivan Vehicle: 2016 Chrysler Town & Country Location: Wrench-A-Part (Austin) Price: $75 - $115 Parts/Fees: I will cover your yard entry fee and the cost of the door. Description: Looking for an experienced mechanic to meet me at Wrench-A-Part to pull a replacement rear hatch off a donor van and swap it onto my 2016 Chrysler Town & Country. I have permission from the yard to park my van directly next to the donor vehicle so there is no long-distance hauling required. They also have wheel barrows. What you will be doing: * Remove Donor Hatch: Disconnect the donor van's wiring harness, unclip the hydraulic liftgate struts, and unbolt the rear hatch at the roof hinges. * Swap Hatch: Unbolt my damaged hatch, transfer the replacement hatch onto my van, and secure the hinge bolts. * Reconnect Wiring: Reconnect the rubber wiring harness boot so the rear backup camera, taillights, rear wiper, and power locks function properly. What to bring: * Full metric socket set and ratchets (for roof hinges) * Cordless impact driver or ratchet (highly recommended) * Flathead screwdrivers and interior trim-removal tools * Prop rod or support (to hold the hatch up while unbolting/bolting) * Closed-toe shoes (required for entry)

Vehicle: 2016 Chrysler Town & Country (3.6L Pentastar V6) Location: North Austin (Walnut Creek) Parts/Tools Supplied: Yes (New throttle body gasket, resonator grommets, dielectric grease, 24mm socket, and torque wrench) Description: Looking for an experienced mobile mechanic to help me wrap up a repair on my van and diagnose a few codes. I got halfway through fixing some issues from a botched oil change, but the plastic intake is fighting me and I need a pro to take over. What I need help with: * Seat the air resonator: I have the new throttle body gasket, new rubber mounting grommets, and dielectric grease. I just can't get the resonator to pop onto the engine's ball studs. Might need silicone spray and the right touch to get it flush. * Double-check my oil cap: I just installed a new oil filter cap (with the built-in bypass) to address a P06DD code. Once the intake is on and we can start the engine, I have a 24mm socket and torque wrench here for you to use to verify my torque and check for pressure leaks. * Diagnose a P0305 and P0420: The intake resonator is off right now, so the cylinder 5 coil is sitting wide open. Need you to test the coil/wiring for the misfire, run live data on the O2 sensor for the cat code, and let me know your professional diagnosis on what's actually failing. Stuff to bring: * Silicone spray or white lithium grease (just in case my dielectric grease doesn't cut it for the intake grommets) * OBD2 scanner that reads live data * Basic hand tools and socket set (10mm, etc.)

I need my alternator replaced and I already have the part so this is labor only

Need to change the uptake oxygen sensor in my 2017 base Kia soul. I have the part I just need the labor.

I need someone to replace my serpentine belt. I have the part.

Replaced ignition coil wired in the new one now i have a short that keeps popping either my main fuse or the ignition fuse. Its my daliy rider

I need the stereo head unit replaced in my 2019 Nissan Frontier. I have a 8 Core 6G+128G Android Stereo with Wireless Carplay and Android Auto, 1280P 9 Inch Double DIN Touchscreen Radio with Bluetooth, Mirror Link, WiFi, GPS, Steering Wheel Control, FM/RDS, DSP, USB, backup camera from Driauto. I have the wire harness Kit and dash kit.

Installing only my back seat covers on today

I've purchased a set of OEM Ford LED headlights for a 2021 Ranger (Lariat trim) and want them installed on my 2021 Ranger XLT. Need assistance to remove the existing units and install the new ones - apparently front grill and bumper cover needs to come off. Not sure about coding for LED etc. Obviously, I'd like someone experienced with this type of work, so it's not busted up. I've got the OEM LED headlights already (see photos).

diagnostic for egr valve.

I was driving to work and my car stopped in the middle of the road and was saying low oil but I just had an oil change less than 1 month ago and we added oil after it being towed. Will try to crank and make noise and lights come on but no start

I’m shopping for my aunt. She has a 2022 Toyota Highlander hybrid. She is traveling cross country. She has all the parts to convert to a 110 system. Looking for someone who can do the labor.

My 2009 Toyota Matrix needs a new alternator, belt, and battery installed. I just don’t have the tools to take everything out myself. I've got all the parts I need installed, just someone with the tool kit to get it done. Thanks!

Description I have a 2023 Subaru Forester with a loud, consistent rattle coming from the driver side area. It seems like it is either inside the dashboard near the driver side, or inside the driver side door panel. What I need 1. Meet in person and go on a short test drive with me to confirm the exact source of the noise. 2. Remove any necessary trim panels safely and locate the cause of the rattle. 3. Fix it properly using automotive-safe methods, like foam tape, felt tape, clips, fasteners, padding, or re-seating panels. 4. Reassemble everything cleanly with no scratches, gaps, or new rattles. Requirements • Experience with interior trim removal and rattle diagnosis. • Bring your own trim removal tools and materials. • Please include in your offer what you plan to do and your relevant experience. Notes - I am not asking for electrical work or modifications.

I replaced the battery, fuel filter, spark plug. My ruckus still wont start.

Yes I need a fuel pump which I already have the replacement put in on a Ford F-150 and the fuels assembly lines need to be done and then on a 2007 Honda Accord I need a timing belt replaced

Need a mechanic with own tools to come and replace the spark plugs that I just bought. Four-cylinder Hyundai ELANTRA. 2023 on 96K miles, Thanks

Replace my intake gaskets on my 2014 Nissan maxima

I need a alternator replaced on a 2013 Ford edge. It has a 6 cylinder engine

Honda Fury 2010, hasn't been driven for 2+ yrs and looks like fuel tank is rusted. Only 2100 miles driven. Actually show room condition.