5 Rendering and resurfacing in St Kilda

Patching of internal render

Patch a wall in my house. Roughly 40cm in length and 1m in width.

Need to fill in chases in a brick wall and match texture of existing render as close as possible. There are four patches to be done.

There are two patches on the side walls of our building that need repairs. One is approximately 5m wide x 1 / 2m high and the other is about 3m x 1m. Paint over the top to match existing wall colour. I am not familiar with the costs of this project, so please do not be offended by the quote / cost I plug in here.

We are looking for someone to render our home white and supply own materials to complete this job. We'd like the job done in the next few weeks. We prefer a Saturday or Sunday, but can negotiate this. House width is 7 metres. The height to the top point of the house is about 6 metres. Looking forward to hearing from people interested. Experience required. Thanks!

grind/sand back filler / concrete and rerender surface

I need a fake fire place / shelf removed (its brick i believe) and the complete wall rendered. The wall is approx 4.5m x 2.6m

So the basin/sink has been pushed into its place but can be pushed back out. I need tiling around the sink area and just under the basin. I have sent you a picture of the existing tile on the bathroom floor so that you can tell me if we can find something like that. The bath tub requires a telephone tap to be installed onto the wall. And then that area needs to be covered with rendering and tiles. I was thinking of having some small little tiles around the top of the basin and around the tap where the bath tub is.

Need some small booths rendered in bar in St Kilda. Small job.

Need a section of a brick wall rendered to match in with the existing hard plaster.

The outside wall of my bathroom suffered some water damage due to a leak. A small amount of rendering and skirting board was removed. The site has been airing for 6 weeks. I now need that rendering and skirting board to be replaced.

Very small unit in St. Kilda, Victoria, 3182 with brick interior walls, which I have chipped all tiles off. These were concreted on. Jackhammer used to remove. I now need the walls rendered so we can re-tile the bathroom and kitchen. I have vision and images I can send to prospective handymen. Need job done asap so we can tile, and install kitchen. If you are cheap enough, we may even give you the job of tiling, which we may attempt ourselves. Also possibly the Ikea kitchen install, and painting, so opportunity for on-going work. If my offer is too low, feel free to submit a counter-offer. I just need the work done!

Remove screed from apartment bathroom and toilet to be level with rest of floors. Also require rendering in kitchen and bathroom post electrical and plumbing rough in - Due date: Needs to be done on Tuesday, 19th Oct 2021

I need my splash back wall rendered perfectly plumb ready for tiles to go on. The worst part is about 15mm out of level in the worst spot but is only a small section. Needs to be perfectly straight .

Area is only 1m x 0.5m in a bathroom location. Render was damaged when running electrical conduit in the wall.

We need a professional renderer to fix our bathroom walls to plum for the tiler. It's only a small bathroom, 2.7m by 1.7m and 2.5m ceiling. Previously there was tiles floor to mid wall with rendered walls above. We have removed old tiles and started rendering the walls to plum (we used masonry adhesive and cornice cement thinking it would dry quicker) in preparation for floor to ceiling tiles but it doesn't seem to be drying properly and now we need professional help. We need the work done asap. I can send photos. We are in St Kilda

2 storey row house has cracking in the cement render on rear elevations. patches of render need full replacing. cement is approx. 10-15mm thick. site has vehicle by rear lane.

Hi, I need a 3 render of a townhouse . Plans are currently on PDF . Just the external is required to see how different colour scheme would work .