Find a local timber flooring profesional in Melbourne Eastern Suburbs

We have a floating timber floor installed approx. 4-5 years ago. We have a few locations where gaps have opened up, mostly end to end or where boards go under skirting. There is one location where we have a gap along the long edge. Photo of one location provided. 4-5 locations total. We would like these gaps closed up and hopefully ‘glued’ to prevent reopening.

Restore the timber floor surface from a Curling iron heat damage.

I need someone to installed engineered timber flooring glueddown on existing time floor on stamps. do the prep/sanding, or levelling if required. and installed the skirting boards. old skirting are already removed.

Looking for someone experienced in timber floor maintenance to refresh the engineered timber flooring in my apartment (lounge room and kitchen area, vacant currently). The floor is approximately 10 years old, has some light fading, but is structurally in good condition. It does NOT need heavy sanding.I need a good "clean and coat/ buffer” for refresher look.

Looking for someone experienced to remove existing solid timber flooring from a house in Camberwell. Approx. 150 sqm of timber flooring needs to be removed. The flooring is fixed with nails and some adhesive, so experience with timber floor removal is preferred. Care needs to be taken to minimise damage to the Yellow Tongue subfloor underneath. Please provide your quote for labour to remove the timber flooring. 📍 Location: Camberwell 📐 Approx. area: 150 sqm Please message me with your availability and price.

as per pictures need someone to check and help remove stains on timber stairs

The underneath timber is rotten. The decking timber needed to be removed and replace the new underneath timber.

The floor was scratched with a bolt when I was moving in. I tried to fill the scratch myself, which is why the area looks darker now. Need someone to fix it.

Can you fix the defect on the bamboo floor

Rip up carpet and install engineered timber on area. Approx 45sqm. Living area, small bedrooms, kitchen, hallway

I have some(15-18 pieces) Baltic pine 152mm *20 mm that were damaged by borer attacks. I would like them to be replace and make the floor look fresh

I’m looking for someone experienced in repairing floating timber flooring. A section of the floating timber floor, about 1 square metre, has buckled in the middle outside the laundry room. The floor buckles during winter but returns to normal in summer, so the issue appears to be seasonal. As far as I can tell, there is no obvious water damage. I’m looking for someone to inspect the cause and carry out the repair. If the problem is related to insufficient expansion gap or another installation issue, I’d like it repaired properly. Please include: * Your experience with floating timber floor repairs * Your availability * An estimated quote Location: Kew, VIC.

Install direct stick engineered flooring to our bedroom. Floors will be levelled and cleared. Flooring is in next room ready to go. Works will include: -install of direct stick flooring to bedroom and WIR Room size is 3.6 x 3.1 and WIR is 1.3 x2.1 Supplied by me: -4 in 1 Acouslime Glue -Engineered timber flooring tongue and groove Thanks

Fix the Buckled timber floor, roughly 2 sqm,

Looking to improve several worn and scratched areas on existing hardwood timber floors Please advise proposed method (polish, rejuvenator, touch-up etc). Photos attached.

Solid timber flood sanding and re-seal for kitchen only , refer photos just the read area

I have just removed old carpet and would like to have the floors polished. The floors are quite old, and there are some holes and gaps in certain sections of the rooms that will also need to be filled and sealed.

Light sanding of about 20sq m outdoor deck which has been partially chemical stripped there is outdoor power point in middle of deck

We have some holes in our flooring following removal of a large heating unit. Need someone to repair the 3 holes (2 are 2.5cm diameter, 1 is irregular shape with 7cm being the widest). Also there's a second area in the house where we can physically press down along 4 planks which is not able to take a load or walk on. Refer to photos for reference.

Looking for someone experienced with timber floor repairs/restoration to improve several dark/light discoloured patches on existing timber flooring. Scope: • light sanding/feather sanding • colour/stain blending • touch-up of affected boards only • apply matching matte clear coat/poly finish Goal is to make the patches much less noticeable and blend with surrounding boards without fully refinishing the whole floor. Areas are relatively localized (see photos). Would prefer someone with experience in timber floor colour matching and blending repairs. Please include: • similar work/photos if available • products/process used • estimated duration Located in Melbourne. Flexible with timing.