Find professional local plasterers in ACT

Need a handy person or plasterer to patch several small plaster cracks/holes on internal walls and paint to match. Also need to replace and fit 2-3 standard internal hollow core doors (Please supply and install 2-3 standard hollow core doors from Bunnings . I will reimburse materials receipt or include in quote).

Need a handy person or plasterer to patch several small plaster cracks/holes on internal walls and paint to match. Also need to replace and fit 2-3 standard internal hollow core doors (Please supply and install 2-3 standard hollow core doors from Bunnings . I will reimburse materials receipt or include in quote).

Need someone who’s decent at plastering to to plaster these joints and get ceiling paint ready. Area is roughly 2m x 1m

Reposting as I didn’t realise it expired…Looking for Mark. I have an old gas wall heater that I would like removed and disposed of. Once the heater is removed, there will be a large opening left in the wall that will need to be repaired/plastered so the wall is ready for painting (painting not required). Looking for someone with the appropriate experience to complete the job and leave the area neat and tidy.

I need four holes in plaster walls fixed. Two about fist size and two around baskets size. Just need them patched and sanded ready to paint. Don’t need them painted.

I need a hole in a ceiling plastered and sanded smooth to be level with existing ceiling please. Hole was caused by tile falling but roof since fixed. I'd like tomorrow evening for job if possible or afternoon of Tuesday 22 September before 5 pm please.

Looking for someone experienced in shower grouting/repairs to complete a couple of small grout repairs and skim coating in our shower.and kitchen This is a minor job, but we want a neat, professional finish, so please only respond if you have experience with this type of shower/bathroom work. Located in Conder, ACT.

I need someone to patch an area of plaster . Ready for tilling.

Looking for a plasterer to supply and install Gyprock and cornices to a 7.4m x 3.3m steel frame garage. Skillion roof. One end wall has a door/window cutout, the roller door end is completely excluded. Total area is 67m².

can someone patch my wall for a dent??

Rebuild and close in the wall opening to enclose the wardrobe. Internal wall with bedroom on other side. The wall gap is approximately 1.2 metres wide. Works to include timber studs, plasterboard, plastering and skirting, leaving the area neatly finished and ready for painting.

Remove 6 electric heaters and 3 dials and repatch plaster

Need a bit of plastering done in the garage so a garage door can be attached to the frame

I have a small hole in the wall that needs to be plastered. Ideally I’d also like it painted, but that can be a different task if required.

The ceiling around the rangehood flue needs repairing and some parts are sagging. Looking for plaster repair and leveling, sanding and getting ready to paint.

Proven professional gyprocker/plasterer to: 1. Gyprock sheet both sides of a sliding door cavity that has been removed and replaced with studs/noggins ready for sheeting. 2. A non-load bearing wall has been removed (4.5m wide *2.7m high) and gyprock sheet required to lhs and rhs and ceiling where wall removed, including adding cornice to both ceiling sides. 3. Replace gyprock sheets to several ceiling holes that were cut out as inspection ports prior to the wall being removed. Gyprock to be left to a very high standard ready for me to paint. Ignore the far wall in the photo with the insulation batts. That won’t be gyprocked as part of this work. Job can be done in 2 parts: Part 1 to be done ASAP sheet old sliding door cavity and lhs of wall where wall removed. To make way for cabinetry install along that wall. Part 2 : remainder of work over next 4 weeks.

Give us a quote for adding crown moulding to recently renovated kitchen and patch hole from wall heater that has been removed

Need a plasterer to patch up two small marks

I am looking for someone to help repair a small plaster chip on a wall corner, which is roughly the size of a 20-cent piece. As the metal corner bead is slightly exposed, the repair will require appropriate filling and sanding to ensure a smooth, durable finish that sits flush with the wall. Please let me know your availability to take this on, and clarify if you will be bringing your own materials and tools or if there is anything specific you need me to provide. I would also appreciate it if you could confirm your experience with patching and whether you are able to assist with matching the paint finish to the existing wall. Colour matching does not need to be perfect.

Trying to hang a sensory hammock for the kids that needs to be fixed into a joist with 2 bolts. Looking for you to also chuck some spackfiller or w/e in the holes I've drilled. I’ve used a stud finder to find what I thought were the ceiling joists, but driving a nail/drill bit through hits air. The roof has a bedroom above it if that provides any useful info.