Hire a trusted Mechanic in Brunswick

Hi, I need someone to help me with the alarm of my van. It's a Hyundai iLoad 2010 and the alarm is playing up. When I press the button to open the doors, only the driver door opens, and sometimes I need to insert the key to open it. Sometimes when I open the door the alarm goes off, very annoying. I can take the van to you have a look until monday, if its after monday will need someone to visit and fix as I am going out for a while. Dont kow how much would be this service so put your offer and I'll consider each of them. Thanks

Having lots of trouble with my d40, need someone who will fix everything and get it running as it should.

Need reverse camera to be set up. Installed but apparently not enough power running to it to activate while in reverse.

Hi! I need a qualified mechanic to perform a pre-purchase inspection for me this afternoon in Brunswick. It is a 2009 Mazda 2 Auto. Thank you!

Need an urgent jumpstart from Victoria St Brunswick

I have SYM St 200i which is not starting because I had put wrong engine oil. However I Had changed it to write engine oil it is not starting. If one can repair it and start it will be good.

Need Pioneer DMH-Z5350BT installed in my 2009 Mitsubishi triton Ml. I have the wiring harness and headunit. Attempted and couldn't work it out so I need some help. Need done today.

Stepper motor programmed by arduino to rotate one full rotation, pause 2 seconds, then rotate again in the reverse direction. Speed of rotation will be as quick as possible for the motor, with decent torque. Task is split into two parts. First part: A list of the required materials will be needed, so I can order beforehand. This point is important, as if a piece is missing the task will not be completed. Second part: After the parts have been ordered and arrived, likely a week later, the assembly of the circuit and uploading of the code. This may take trial and error to be completed. This Second part must be done in person. Current parts I already have: Arduino starter kit 12v 7.2ah battery, or 9v battery Nema 17 stepper motor Unipolar 0.4A 12v 6 wires ULN2003 driver A4988 driver TB6600 4A driver Multi meter Soldering iron+wire+flux Advice needs to be given on quality of parts. Currently I am using cheap eBay versions of arduino, if better is needed this should be recommended. If a different battery, or motor that is not 6 wires, or better wires ect. this all needs to be recommended.

In the process of restoring a 1972 Honda cb350. Would like somebody to come and inspect engine noise and potentially disassemble/reassemble engine if required. Have required gaskets. May require new kickstart spindle. Bike has 20k miles on it. Want somebody who is specialized in vintage/classic bikes and not a general motorcycle mechanic.

My car is dead and needs to be towed to an auto electrician’s 1.5km or 5 minutes down the road in Brunswick.

Need a Boss BVCP9690A Double-DIN installed into Nissan x trail 2003

Car not Starting.. battery ok

I’ve got two kings LED work lights and a wiring harness and button I need installed on the rear of my ute. I’d like them to be wired up to the second battery located in the engine bay. I can put them on, I just need the wiring done. There is wiring set up with a button in the dash for the reverse bumper sound that can potentially be used for the lights as I want them as reverse lights. Might need extra length of wire to reach the back of the canopy? Not sure. Weekend would be best Car is clean, and I can sanitise and wash vehicle pre install if you like.

Carry speakers, cable, lights etc

Need to replace the timing belt on my: Subaru Forester - 2004 Petrol Manual 2.5 Litres Turbo

After car window tint on a 4wd. Located Coburg but can travel in the 25km radius

The key for my 2009 Hyundai i30 has become dislodged from the car remote. I can still turn the engine on and off but it is a pain. I’d like to get it fixed without paying an arm and a leg as Hyundai has tried to do! Picture attached. It seems to have snapped clean off Timeframe flexible Thank you!

Looking for someone to provide the parking sensor and also install it. Car is silver

Bought a reverse camera online and would like someone to hook it up to a VW Golf 2012. I have attached a picture of the product here. Its just clips on the rear view mirror. I wanted to unit to run independently rather than being powered from the cigarette lighter and also the Reverse camera switches on when the car is put in reverse rather than manually choosing the option on the cam. The Unit works both as a Dash Cam for front and back as well as a reverse camera. Details of the unit : AWESAFE Mirror Dash Cam 10 inch Touch Full Screen Front 1080P Rear 1080P Dual Lesn 170 Degrees Wide Angle Rear View Dash Cam 24 Hours Parking Monitoring

Hi, I need my light bar and 2 spotlights connected on my 2008 Triton. I have all the wiring harness and have already set them up on the bull bar.