Find a professional garage door installer in VIC

Garage doors broken not working they are manual pull ones. One has come off its hinge the other I’m not sure. No idea what this should cost to fix so please quote

Need someone to service/check my garage door opener. The opener is flashing after cycles and the warning label says it may be due for a service after 3,000 cycles. The door is operating, however I’d like someone experienced with garage doors/openers to inspect and service it, and advise if anything needs replacing or adjusting. Located in Mooroolbark. Prefer someone with experience in garage door motors/openers. Please quote including call out/service fee 😊

Garage door stopped working a long time ago and we’ve been putting it down manually. Any solutions??

Set up an automatic garage door

Hinge of garage door is loose the door is sticking. Wooden door. I think the hinge is ok but the screws are rusty. A drawer in a dresser is stuck. A screw came out of the metal runner and the drawer will not close.

We would like someone to spray paint our garage door.

I want to remove the back wall of my garage, including the small access door attached to that wall, and replace the entire opening with a full rolling shutter. The purpose is to create vehicle access so I can drive my car through to the backyard/back side of the house.

Need a quote for exterior painting double story requires boom for gutters and fascia

My Eco Garage door, won’t open, may need a reset

Looking for a licensed locksmith to replace three locks at my Thornbury townhouse: 1. **Front door lock** – replacing the existing deadbolt/lockset (please confirm if you can supply the hardware or if I need to purchase it separately) - we want to have a knob on the inside to lock vs. using a key 2. **Garage lock** – replacing the existing lock on the internal/external garage door - same as front door, we want to lock without a key. 3. **Letterbox lock** – replacing the existing letterbox lock and providing a new key The property is a two-storey townhouse. Happy to discuss lock brands/grades if you have recommendations. Please provide your licence number in your offer and let me know if supply of locks is included in your price or quoted separately,

Scope Replace old shuttle trolley with new trolley for Garage Door Model: ATA Securalift Garage Door Opener Labour only. Will supply new part. Easy access garage door

garage door cant open. I have remote but it doesn’t work.

Paint rendered fence and back garage door

The garage door is stuck and unable to get down

Hi, I’m looking for a quote to repair or replace the lock on my garage door at my property in Frankston. The external T-handle lock is no longer engaging the internal locking mechanism

The base of the garage door has needs to be screwed. I think I will need 3-4 screws to hold it into the door.

*Photo now added* Supply and install 2 x new automatic garage remotes This will be replacing the existing remotes. The garage door is working fine Thank you

The garage door isn't locking. The locking mechanism stops short of the cutout thats supposed to engage the lock. When extended it scrapes against the vertical rail. Would like some sort of service call to make any necessary adjustments so that its working properly. To also test the motor with the remote.

Please provide a quote in your message. The renter has reported that the garage roller door is currently malfunctioning. The door needs to be manually pulled down, and when attempting to operate it via the remote control, the unit emits a continuous beeping sound without completing the closing function. This issue appears similar to one that was raised approximately five years ago, which your team previously attended to and resolved. Based on the current symptoms, it is likely a recurrence of a similar fault. From my initial review of the video provided, I believe the following may be contributing to the malfunction: Signal / Receiver Issue (most likely) The motor appears to have power; however, it may not be receiving the signal from the remote. Possible causes include: Disconnected or damaged antenna wire Fault with the receiver module (control box not communicating correctly) Interference from any added devices (e.g. WiFi/smart automation setup)

Reprogram the control unit and remotes