Find a professional garage door installer in West Brisbane

Add socket for auto garage door by connect directly from mainboard to ceiling all inclusive.

I need a safety beam supplied and installed as well as the meross smart wifi garage door opener we purchased installed

Looking to replace both lift cables on a standard sectional garage door. Door is in good condition, just needs new cables and proper tensioning. • Replace both cables • Check drums + springs • Re‑tension and ensure smooth operation • Confirm door opens/closes safely

We are building a new carport and need installation of a double garage door. We're looking for something economical and cheaper priced (rather than premium door style). Plan is attached

I have a plastic concertina door that I need someone to install for the laundry area . It includes cut the metal rail sliding the doors and installing to the wall . Maybe also cutting the timber panel below . Also need someone to replace the handle for the garage and probably the two wires so the door will be close properly . Might also need to oil and strength the other metal components of the door . Both of them are quite easy tasks for someone with experience

Need someone to repair a tilt single old garage door

Need someone to fit a panel too my garage door and provide a receipt after to show real estate

l accidentally drove into my automatic garage door and it's now bent is opening but not closing properly. Looking for someone to come onsite, assess and fix it

My remote control has two buttons, one opening the sliding fence gate, and the other the batwing hinged doors to the carport. The carport doors are not responding to the remote control. As I expect it would be difficult to assess the time it would take to fix this, I would prefer an hourly rate, and am proposing $80 an hour.

I want garage door motor to be moved to make the rail shorter. I want both the centre and side guide rails to be made shorter. Not sure how much it will cost so please provide your quote.

To trouble shoot the steel line garage door controller. likely issue 433 MHz receiver module. works only when remote used close to the controller. To replace components or board.

motor requires reset, door fully operational

motor needs to be reset, door fully operational

Garage Door Repair – 6m Sectional Panel Door Looking for an experienced garage door technician to service and repair a 6m wide x 2.2m high sectional door. Issues: Cables have come loose. Bottom cable brackets/anchors are missing and incorrectly secured with tek screws — need proper replacements. Torsion shaft — replacement needed. May require an additional torsion spring for balance. Door might need stiffening/reinforcement. Scope: Inspect and diagnose. Supply and install correct cables, bottom brackets, and tension components. Replace torsion tube and/or add spring if required. Ensure the door runs smoothly and safely. Please quote labour + parts and advise availability. House is tenanted, but door is in open position and easily inspectable from footpath. I will just need to let tenants know.

Double sectional garage door does not work smooth

I accidentally left my garage door open and i’m out of town. I urgently need someone to go to the house press the garage door button and run out.

We need an electrician to install a garage door opener on a single garage. It is currently a manual lock up metal garage door. There is an electrical line running near where the opener would need to be installed but no existing outlet. We would pay for opener and agreed upon materials such as outlet if needed etc. Suggestions appreciated for what to purchase.

B & D roller door needs resetting

Garage door is buckled needs to be fixed

Replace existing garage door, motor is ok just the door is damaged.