Find a professional gate installation in TAS

Hi need my gate looked at please it’s a electric gate opens but doesn’t close

Gate jammed after swelling with rain. Another gate slightly stuck.

I need a gate and front fence put up. It isn’t a big fence. I have the gate.

Replace broken latch on gate

We have a 3m farm gate from Bunnings. 2 wooden posts, hinges and cement, but don’t have the equipment (or enjoy) digging 80cm deep for the posts. We’re looking for someone to dig the holes, cement the posts and then come back later to put up the gate.

I need my lock fixed on my gate as it doesn’t lock or shut properly.

Need a fence and gate repaired, as the postie slammed his scooter. Minor repair needed, open for further discussion. As need few other things done on the property as well.

1. Install door closer (pictured) 2. Timber strips screwed into brick to aid function of timber gate 3. Drill. Rick for 4 screws to hang pictures on outside walk

Strip and rewire garden gates ready for painting

Small amount of soil to remove and box up before concreting and finishing.

Need a fence and gate repaired, as the postie slammed his scooter. Minor repair needed

Need to spot weld a hinge at the bottom of the gate

Long swinging gate on the side of my house. I need the slope pictured underneath the gate covered to prevent dog from escaping, but still able to swing open.

I need three farm gates installed and the three farm gates will need potentially poles either side to secure to and fencing either side on two of the gates ,would require someone to come out and measure up.

I need a new gate and fence (~4.5 m long) - both ~1.5 m high at the bottom of our driveway.

Hi, We are just finishing a renovation and have two gates (front and back of property) That need a sand down (rust) and painted Monument. They are spanning approx. 2m each side.

I need a simple gate to hide firewood. It needs two hinges and just needs to open and close.

I need my gate fixing its broken at the hinges. Might need parts see photos

Looking to have 2 gates made up and installed one each side of the house. One is approx 1200mm wide and will install between boundary fence and extend off our white picket fence (as shown in photo). The other is approx 980mm wide and will install between boundary fence and our house. Basically I'm after a basic timber gate to match the house and blend in seamlessly. Please quote appropriately

Make fence straight and sturdy again, add gates, and secure existing gates.